Troubleshooting guide

FOR SERVICE TECHNICIAN ONLY - DO NOT REMOVE OR DESTROY
PAGE 17
TEST #8 Water Valve
Activate the DiagnosticTest Mode as shown
on page 2.Press Start and verify that water is
being sprayed in the drum. See figure 13.
If no water is sprayed in the drum:
1. Perform steps inAccessing & Removing the
ElectronicAssemblies, and check that the wires
are connected to the water valve relay on the
machine control electronics.
2. Check that water is hooked up and turned on.
3. Inside the drum, unscrew and replace the
water nozzle using a 7/16" wrench or socket.
4. Remove the back panel,then:

Check that the wires and hose are connected
to the water valve assembly.

Check that the water valve assembly hose is
connected to the nozzle.
5. If everything is hooked up and the water still
does not dispense:

Unplug dryer or disconnect power.

Replace the valve assembly.
6. Plug in dryer or reconnect power.
7. Activate the Diagnostic Test Mode, page 2,
and check to make sure water is being sprayed
into the drum.
8. If water is still not dispensed:

Unplug dryer or disconnect power.

Replace the machine control electronics.
ACCESSING & REMOVING THE
ELECTRONIC ASSEMBLIES
There are two electronic assemblies: the Machine
Control Electronics and the Console Electronics
and Housing.
Accessing the Electronic Assemblies
1. Unplug dryer or disconnect power.
Removing the Machine Control Electronics
2. Remove all three screws from the rear console
panel.
3. Remove all wire connections from the machine
control electronics.
4. Push the machine control electronics forward
and upto release fromthe rear locking tab.
5. Remove the control.
Removing the User Interface Assembly
2. Using the special tool, pry and loosen the front
console panel as shown in figure 14, making sure
to loosen the fascia all the way around the panel
to disconnect all of the clips.Separate it from the
console assembly, and flip it forward onto the
dryer cabinet.
3. Disconnect two wire harness connections
from the assembly.
Water Valve Wires
Water Nozzle
Water Valve Assembly
Figure 13. Water system components.
Figure 14. Loosen and remove the front fascia.