Installation instructions

Remove the door assembly

1. Remove the 3 plugs with a at head screw driver. There

is a cut out to stick the screwdriver under to pop out.

2. Remove the 10 screws from the dryer door and set

screws off to the side.

3. Remove the inner door by taking a plastic putty knife to

separate the sides and bottom of the dryer door and trim.

There are 2 snaps on left, right, and bottom of door. Insert

the putty knife next to the snaps.

4. When you have the door separated from the frame use a putty

knife and lift up in the center tab and then pull door towards

you and out. Lay the door on a at, covered surface, with the

inside of the door facing up.