Installation Instructions

†

TORX, T20, and T25 are registered trademarks of Acument Intellectual Properties, LLC.

DOOR REVERSAL (OPTIONAL)

The following instructions are for models with round and

square-shaped doors.

#2 Phillips screwdriver

Min. 8" (203 mm) long

TORX

, T20

and

T25

†

screwdrivers

Tools needed:

Using a Phillips screwdriver, remove middle screw in hinge.

Disconnect wiring. Tuck wiring into opening.

REVERSE DOOR SWING: ROUND-SHAPED DOOR

IMPORTANT: If the protective film has not yet been removed from

the dryer, peel the film from the dryer door before proceeding.

Using a T25

screwdriver, remove the four screws securing the

door hinge to the dryer and lift the door up and out to remove.

Place the door on a soft towel or other non-scratch surface.

DOORS WITH ELECTRICAL WIRING:

ALL DOORS:

Using a T25

screwdriver, remove the two screws securing the

door strike to the door frame of the dryer. Rotate the strike 180°

and attach to the opposite side of dryer door frame with the two

screws removed earlier, as shown.

2. Remove door from dryer

1. Disconnect wiring from door

3. Move the door strike

WARNING

Electrical Shock Hazard

Disconnect power before servicing.

Replace all parts and panels before operating.

Failure to do so can result in death or electrical shock.