Installation Instructions

26
Flip over the inner door to the left. Using a T20
®
screwdriver,
reinstall the hinge assembly on the opposite side from which it
was removed.
DOORS WITH ELECTRICAL WIRING:
Lift off inner door assembly. Using a Phillips screwdriver, remove
the two screws securing the rotating assembly to the door.
Reposition rotating assembly and tubing 180° to opposite side of
the door.
Rotate bottom of assembly 180° towards you and secure
assembly with the two screws removed earlier, using a Phillips
screwdriver. Press tubing into indents.
IMPORTANT: Make sure to swing hinge down in front of rotating
assembly (see Step 12).
9. Remove rotating assembly
8.
Reinstall hinge assembly on opposite side
10. Reposition rotating assembly
and tubing
11. Rotate assembly bottom and fasten
in place
Press tubing
into indents.