Installation Guide

9. Reinstall inner door assembly

Position the door with the inside of the door facing up.

Reinstall the 10 screws securing the inner door to the

outer door.

10. Reinstall door on dryer

Using a T25

screwdriver, remove the 4 screws on the dryer.

Insert the tabs on the hinge into the mounting slot and slide

down to engage the top tab. Secure in place with the

4 T25

screws removed earlier.

Bottom

of door

1. Remove door from dryer

IMPORTANT: If the protective ﬁlm has not yet been removed

from the dryer, peel the ﬁlm from the dryer door before

proceeding.

Using a T25

screwdriver, remove the 4 screws securing the

door hinge to the dryer and lift up and out to remove the door.

Place the door on a soft towel or other non-scratch surface.

Reinstall the 4 screws in the holes.

Reverse door swing round-shaped door with ﬂat

glass – double handle

2. Move the door strike

Using a T25

screwdriver, remove the 2 screws securing the

door strike to the door frame of the dryer. Rotate the strike

180° and attach to the opposite side of dryer door frame

as shown.