Installation guide

18
IMPORTANT: If the protective lm has not yet been
removed from the dryer, peel the lm from the dryer door
before proceeding.
Using a T25
®
screwdriver, remove the 4 screws securing the
door hinge to the dryer and lift up and out to remove the door.
Place the door on a soft towel or other non-scratch surface.
Reinstall the 4 screws in the holes.
Reverse door swing round-shaped door with at
glass – single handle
#2 Phillips screwdriver
Min. 8" long TORX T25
® †
screwdriver
Tools needed:
DOOR REVERSAL (OPTIONAL)
The following instructions are for models with round and
square-shaped doors.
1. Remove door from dryer
COMPLETE INSTALLATION
CHECKLIST
q
Check that all parts are now installed. If there is an extra
part, go back through steps to see what was skipped.
q
Check that you have all of your tools.
q
Dispose of/recycle all packaging materials.
q
Be sure the water faucets are on.
q
Check for leaks around “Y” connector, faucet, and hoses.
q
Check dryer’s nal location. Be sure vent is not crushed
or kinked.
q
Check that dryer is level. See “Level Dryer.”
q
Remove lm on console and any tape remaining on dryer.
q
Wipe dryer drum interior thoroughly with a damp cloth
to remove any dust.
q
Read “Dryer Use” in your Use and Care Guide.
q
For power supply cord installation, plug into a grounded
outlet. For direct wire installation, turn on power.
q
If you live in a hard water area, use of a water softener is
recommended to control the buildup of scale through the
water system in the dryer. Over time, the buildup of lime
scale may clog different parts of the water system, which will
reduce product performance. Excessive scale buildup may
lead to the need for certain part replacement or repair.
q
Select a Time Dry heated cycle, and start dryer. Do not select
Air Only Temperature setting.
If dryer will not start, check the following:
• Controls are set in a running or “On” position.
• Start button has been pushed rmly.
• Dryer is plugged into an outlet and/or electrical supply.
• Household fuse is intact and tight, or circuit breaker
has not tripped.
• Dryer door is closed.
This dryer automatically runs an installation diagnostic routine
at the start of its rst cycle.
NOTE: You may notice an odor when dryer is rst heated.
This odor is common when heating element is rst used.
The odor will go away.