Installation guide

4. Remove outer window assembly

from trim ring

Using a Phillips screwdriver, remove the 2 screws from the

outer window retainer and rotate the outer window assembly

clockwise until the square notches line up with the 4 tabs on

the trim ring indicated with arrows in the gure A above. Then

lift out the outer window and retainer up and off the trim ring

and set aside (B).

Fig. A

Fig. B

†

®TORX and T25 are registered trademarks of Acument Intellectual Properties, LLC.

2. Move the door strike

Using a T25

screwdriver, remove the 2 screws securing the

door strike to the door frame of the dryer. Rotate the strike

180° and attach to the opposite side of dryer door frame

as shown.

Remove inner door from outer door

Position the door with the inside of the door facing up.

Using a Phillips screwdriver, remove the 10 screws securing

the inner door to the outer door. Lift off the inner door and

set aside.