Installation guide

22
3. Remove inner door from outer door
Position the door with the inside of the door facing up.
Using a Phillips screwdriver, remove the 10 screws securing
the inner door to the outer door. Lift off the inner door and
set aside.
4. Remove hinge and latch
Using a T25
®
screwdriver, remove the 3 screws securing the
latch plate and latch backing plate and the 5 screws holding
the hinge assembly in place.
Hinge
Latch
5. Reinstall hinge and latch
on opposite sides
Using a T25
®
screwdriver, reinstall the latch plate and latch
backing plate with the 3 TORX
®
screws removed earlier and
the hinge assembly with the 5 screws on the opposite sides
from which they were removed.
2. Move the door strike
Using a T25
®
screwdriver, remove the 2 screws securing the
door strike to the door frame of the dryer. Rotate the strike
180° and attach to the opposite side of dryer door frame
as shown.