Troubleshooting guide

PAGE 23
FOR SERVICE TECHNICIAN’S USE ONLY
DO NOT REMOVE OR DESTROY
B: Remove Front Panel
(Refer to Figure 17, unless otherwise noted.)
6. Disconnect door switch connector
(See Figure 16, page 22).
7. Remove front panel by removing nine
screws—four from the bottom, three from the
top, and two below the dryer door opening.
C: Remove Front Bulkhead
(Refer to Figure 18, unless otherwise noted.)
8. Remove lint screen.
9. Unclip main wire harness (2 places).
10. Disconnect drum light connector
(See Figure 16, page 22).
11. Disconnect moisture sensor at plug below
door opening.
12. Remove console mounting bracket by
removing six screws—four from the top and
two from the front (bold arrows).
13. Remove lint duct cover by removing three
screws—one screw and clamp assembly at
bottom of cover and two screws securing
cover to bulkhead.
14. Remove the four screws securing the
bulkhead to the cabinet. Remove bulkhead.
D: Remove Drum
15. Remove drive belt from belt switch pulley.
16. Pull drum from cabinet.
17. Reverse procedure to reassemble.
Figure 17 - Remove front panel.
Figure 18 - Remove front bulkhead.
Console Mounting Bracket
Front Panel
Drum Light
Main Harness Clips
Lint Duct
Cover Screws
and Clamp
Moisture Sensor
Connector
Bulkhead
Screws