Measurement Guide

Because Whirlpool Corporation includes a continuous commitment to improve our
products, we reserve the right to change materials and specifications without notice.
Dimensions are for planning purposes only. For complete details, see Installation
Instructions packed with product. Specifications subject to change without notice.
Page 2 of 2
Ref. W11085332A
05/31/2017
ELECTRICAL REQUIREMENTS - U.S.A. ONLY
Electrical Connection
To properly install your range, you must determine the type of electrical
connection you will be using and follow the instructions provided for it
here.
■ Range must be connected to the proper electrical voltage and
frequency as specified on the model/serial/rating plate. The model/
serial/rating plate is located behind the oven door on the top right-
hand side of the oven frame.
■ This range is manufactured with the neutral terminal connected to
the cabinet. Use a 3-wire, UL Listed, 40- or 50-amp power supply
cord (pigtail). See the following Range Rating chart. If local codes
do not permit ground through the neutral, use a 4-wire power supply
cord rated at 250 volts, 40- or 50-amps and investigated for use with
ranges.
Range Rating*
Specified Rating of
Power Supply Cord Kit
and Circuit Protection
120/240 Volts 120/208 Volts Amps
8.8 - 16.5 KW 7.8 - 12.5 KW 40 or 50**
16.6 - 22.5 KW 12.6 - 18.5 KW 50
* The NEC calculated load is less than the total connected load listed on
the model/serial/rating plate.
** If connecting to a 50-amp circuit, use a 50-amp rated cord with kit. For
50-amp rated cord kits, use kits that specify use with a nominal 1
3
/
8
"
(3.5 cm) diameter connection opening.
■ A circuit breaker is recommended.
WARNING
Electrical Shock Hazard
Electrically ground range.
Failure to do so can result in death, fire, or
electrical shock.