Specification

Page 1 of 2
Because Whirlpool Corporation policy includes a continuous commitment to improve
our products, we reserve the right to change materials and specifications without notice.
Dimensions are for planning purposes only. For complete details, see Installation
Instructions packed with product. Specifications subject to change without notice.
Ref. W10665256E
5/16
PRODUCT MODEL NUMBERS
WEG730H0D WEG760H0D WEG745H0F
GAS SUPPLY REQUIREMENTS
Gas supply line:
■ Provide a gas supply line of
3
⁄
4
" (1.9 cm) rigid pipe to the range location. A smaller
size pipe on longer runs may result in insufficient gas supply. With LP gas, piping or
tubing size can be
1
⁄
2
" (1.3 cm) minimum. Usually, LP gas suppliers determine the
size and materials used in the system.
NOTE: Pipe-joint compounds that resist the action of LP gas must be used. Do not
use TEFLON
®
† tape.
Flexible metal appliance connector:
■ If local codes permit, a new CSA design-certified, 4 to 5 ft (122 to 152.4 cm) long,
1
⁄
2
"
(1.3 cm) or
3
⁄
4
" (1.9 cm) I.D., flexible metal appliance connector may be used for
connecting range to the gas supply line.
■ A
1
⁄
2
" (1.3 cm) male pipe thread is needed for connection to the female pipe threads
of the inlet to the appliance pressure regulator.
■ Do not kink or damage the flexible metal tubing when moving the range.
■ Must include a shutoff valve:
The supply line must be equipped with a manual shutoff valve. This valve should
be located in the same room but external to the range opening, such as an adjacent
cabinet. It should be in a location that allows ease of opening and closing. Do not block
access to shutoff valve. The valve is for turning on or shutting off gas to the range.
Gas Pressure Regulator
The gas pressure regulator supplied with this range must be used. The inlet pressure
to the regulator should be as follows for proper operation:
Natural gas:
Minimum pressure: 5" WCP
Maximum pressure: 14" WCP
LP gas:
Minimum pressure: 11" WCP
Maximum pressure: 14" WCP
Contact local gas supplier if you are not sure about the inlet pressure.
A
B
C
30" (76.2 cm) Slide-in Gas Range
PRODUCT DIMENSIONS
This manual covers several models. Your model may appear different from the models
depicted. Dimensions given are maximum dimensions across all models.
IMPORTANT: Range must be level after installation. Follow the instructions in the
“Level Range” section. Using the cooktop as a reference for leveling the range is not
recommended.
* Range can be raised approximately 1" (2.5 cm) by adjusting the leveling legs.
Type of Gas
Natural gas:
■ This range is factory set for use with Natural gas. See “Gas Conversions” section.
The model/serial rating plate located behind the control panel has information on the
types of gas that can be used. If the types of gas listed do not include the type of gas
available, check with the local gas supplier.
LP gas conversion:
Conversion must be done by a qualified service technician. No attempt shall be made to
convert the appliance from the gas specified on the model/serial rating plate for use with
a different gas without consulting the serving gas supplier. See “Gas Conversions” section.
†®
TEFLON is a registered trademark of Chemours.
B
D
A
F
E
C
A. 1
3
⁄
16
" (3.0 cm) height from
cooktop to top of vent
B. 29
7
⁄
8
" (75.9 cm)
C. Model/serial number plate
(located behind the oven door
on the top right-hand side of
the oven frame)
D. 36" (91.4 cm) height to top of
cooktop edge with leveling
legs screwed all the way in*
E. 28
5
⁄
16
" (71.9 cm) max. depth
from front of console to back
of range.
F. 28
7
⁄
8
" (73.3 cm) max. depth
from handle to back of range.
A. Gas supply line
B. Shutoff valve “open” position
C. To range