Service Manual
Table Of Contents
- Service Manual - 27" Gas & Electric Stacked Laundry Center, L-95
- Table of Contents
- Section 1 - General Information
- Section 2 - Diagnostics & Troubleshooting
- Diagnostic Guide
- Diagnostic LED-Main Control
- Self Diagnostic Test Modes (Washer)
- Activating the Service Diagnostic Test Modes (Washer)
- Unsuccessful Entry
- Exiting the Service Diagnostic Test Modes (Washer)
- Customer Viewable Fault Codes (Washer)
- Fault/Error Codes Chart (Washer)
- Automatic Test Mode Chart (Washer)
- Manual Test Mode Chart (Washer)
- Washer Troubleshooting Guide
- Dryer Troubleshooting Guide
- Section 3 - Testing - Washer
- Section 4 - Testing - Dryer
- Section 5 - Component Access
- Product Specifications & Warranty Information Sources
2-6
n
27” Stacked Laundry Center
DIAGNOSTICS & TROUBLESHOOTING
For Service Technician Use Only
WARNING
Electrical Shock Hazard
Disconnect power before servicing.
Failure to do so can result in death or
electrical shock.
Replace all parts and panels before operating.
See page 2-3 to access Fault Code Display Mode.
* If the Sense/Fill LED is ON, the fault code is represented; if
OFF, the error code is represented.
= ON
FAULT NUMBER ERROR NUMBER
Explanaon & Recommended Procedure
(Status LED names may vary between makes and models)
SENSE
FILL
WASH
RINSE
DRAIN
SPIN
DONE
SENSE
FILL
WASH
RINSE
DRAIN
SPIN
DONE
F0E0 - NO FAULT On 8 4 2 1 8 4 2 1
F0E2 - OVERSUDS CONDITION DETECTED F E 2
Fault is displayed when suds prevent the basket from spinning up to speed or the pressure sensor detects rising suds level. The
main control will ush water in aempt to clear suds. If the water ush is unable to correct the problem, this may indicate:
• Not using HE detergent.
• Excessive detergent usage.
• Check pressure hose connecon from tub to pressure sensor. Is hose pinched, kinked, plugged, or leaking air?
• Mechanical fricon on drive mechanism or basket (clothing between basket and tub).
F E 4
Fault is displayed when washer detects water temperature 105°F (40°C) or higher during rinse cycle.
• Hot water geng in. Make sure inlet hoses are connected correctly.
F E 4 1
Fault is displayed when an o balance condion is detected.
• Check for weak suspension. Basket should not bounce up and down more than once when pushed.
• Clothing should be distributed evenly when loading.
F 1 E 1
Indicates a main control fault.
• See TEST #1: Main Control, page 3-5.
F 1 E 2
Indicates a fault of the motor control secon of the main control.
• See TEST #3b: Drive System – Motor, page 3-10.
F 2 E 1
One or more keys on the User Interface were actuated for 15 consecuve seconds.
• Fault occurs during Diagnosc Test Mode if a stuck key is detected.
• See TEST #4: Console and Indicators, page 3-12.
Connued on next page . . .