Service Manual
Table Of Contents
- Service Manual - 27" Gas & Electric Stacked Laundry Center, L-95
- Table of Contents
- Section 1 - General Information
- Section 2 - Diagnostics & Troubleshooting
- Diagnostic Guide
- Diagnostic LED-Main Control
- Self Diagnostic Test Modes (Washer)
- Activating the Service Diagnostic Test Modes (Washer)
- Unsuccessful Entry
- Exiting the Service Diagnostic Test Modes (Washer)
- Customer Viewable Fault Codes (Washer)
- Fault/Error Codes Chart (Washer)
- Automatic Test Mode Chart (Washer)
- Manual Test Mode Chart (Washer)
- Washer Troubleshooting Guide
- Dryer Troubleshooting Guide
- Section 3 - Testing - Washer
- Section 4 - Testing - Dryer
- Section 5 - Component Access
- Product Specifications & Warranty Information Sources
DIAGNOSTICS & TROUBLESHOOTING
27” Stacked Laundry Center
n
2-7
For Service Technician Use Only
FAULT NUMBER ERROR NUMBER
Explanaon & Recommended Procedure
(Status LED names may vary between makes and models)
SENSE
FILL
WASH
RINSE
DRAIN
SPIN
DONE
SENSE
FILL
WASH
RINSE
DRAIN
SPIN
DONE
F 8 4 2 1 E 8 4 2 1
The switches do not match the console or are not operang correctly.
• Fault occurs during Diagnosc Test Mode if a switch mismatch is detected.
• See TEST #4: Console and Indicators, page 3-12.
F 2 1 E 1
Fault is displayed when the Main Control detects an out of range pressure signal.
• Check pressure hose connecon from tub to pressure sensor. Is hose pinched, kinked, plugged, or leaking air?
• See TEST #5: Water Level, page 3-13.
F 4 1 E 1
Fault is displayed if lid is in locked state, but lid switch is open; control not sensing the strike in the lid lock.
• User presses Start with lid open.
• The main control cannot detect the lid switch opening and closing properly.
• Strike not assembled correctly on the lid.
• Lid lock bezel not installed correctly (must be square to embossing and ush to top).
• See TEST #7: Lid Lock, page 3-15.
F 4 1 E 2
Fault is displayed if lid lock has not moved into locked posion or motor cannot be powered.
• Lid is not closed completely due to interference.
• Check for lock interference with lock striker.
• Wash media buildup (detergent, lint, etc.) is prevenng the lock mechanism from sliding.
• Main control detects open lid switch when aempng to lock.
• Main control cannot determine if lid lock is in a locked state.
• See TEST #7: Lid Lock, page 3-15.
F 4 1 E 2 1
Fault is displayed if lid lock has not moved into unlocked posion or motor cannot be powered.
• Check for lock interference with lock striker.
• Main control cannot determine if lid lock is in an unlocked state.
• See TEST #7: Lid Lock, page 3-15.
F 4 1 E 4
Fault is displayed if the following condions occur:
• User presses Start aer several consecuve washer cycles without opening lid.
• See TEST #7: Lid Lock, page 3-15.
Connued on next page . . .