Service Manual

COMPONENT ACCESS
27” Stacked Laundry Center
n
5-15
Removing the Dryer Assembly (continued)
7. Locate the pressure hose disconnect inside the cabinet,
to the right of the motor (see Figure 3). Disconnect hose
ng and pull hose down through opening in dryer base.
Disconnect hose ng
Figure 3
8. Disconnect the three harness connectors to the right of
the water inlet valve assembly (Water Valve/Lid Switch/
Motor & Shier Harnesses). See Figure 4.
Disconnect 3 connectors
Water Inlet Valve
Figure 4
9. Use a Phillips screwdriver to remove three screws securing
the center transion panel to cabinet (see Figure 5).
Loosen center Phillips screw
Remove Right and Le Phillips screws
Figure 5
10. Lower transion panel and remove from cabinet.
11. From the front of the unit, remove one (1) screw per side
aaching dryer support frame to the washer top.
Remove 1 screw from each side
Figure 6
IMPORTANT: The following steps must be performed by two
(2) people.
12. With two people, one removing screws and the other
supporng the dryer. From the back, remove three (3)
5/16” screws per side aaching dryer to washer top. See
Figure 7.
Step 12
Figure 7
13. Remove one 5/16” screw per side aaching dryer to
triangle bracket. See Figure 8.
Step 13
Figure 8