Service Manual
Table Of Contents
- Service Manual - 27" Gas & Electric Stacked Laundry Center, L-95
- Table of Contents
- Section 1 - General Information
- Section 2 - Diagnostics & Troubleshooting
- Diagnostic Guide
- Diagnostic LED-Main Control
- Self Diagnostic Test Modes (Washer)
- Activating the Service Diagnostic Test Modes (Washer)
- Unsuccessful Entry
- Exiting the Service Diagnostic Test Modes (Washer)
- Customer Viewable Fault Codes (Washer)
- Fault/Error Codes Chart (Washer)
- Automatic Test Mode Chart (Washer)
- Manual Test Mode Chart (Washer)
- Washer Troubleshooting Guide
- Dryer Troubleshooting Guide
- Section 3 - Testing - Washer
- Section 4 - Testing - Dryer
- Section 5 - Component Access
- Product Specifications & Warranty Information Sources
5-18
n
27” Stacked Laundry Center
COMPONENT ACCESS
Removing the Dryer Rear Panel
WARNING
Electrical Shock Hazard
Disconnect power before servicing.
Failure to do so can result in death or
electrical shock.
Replace all parts and panels before operating.
To Remove the Dryer Rear Panel
1. Unplug dryer or disconnect power.
2. Turn o water supply to washer.
3. Disconnect hot and cold inlet water hoses and dryer vent.
4. If stacked laundry center is a gas unit:
a. Turn o gas valve.
b. Disconnect gas supply line.
5. Remove Rear Dryer Panel. Use a 5/16” driver to remove
the (9) hex head screws securing the dryer rear panel to the
dryer cabinet and three screws from the top. See Figure 1.
Remove 9 screws from back
Remove 3 screws from top
Figure 1