Service Manual

DIAGNOSTICS & TROUBLESHOOTING
27” Stacked Laundry Center
n
2-9
For Service Technician Use Only

 FAULT NUMBER ERROR NUMBER
Explanaon & Recommended Procedure
(Status LED names may vary between makes and models)
 
SENSE FILL WASH RINSE DRAIN SPIN DONE SENSE FILL WASH RINSE DRAIN SPIN DONE
 F 8 E 2 1
Fault is displayed when main control senses water level that exceeds the washer’s capacity.
• May signify problem with inlet water valves.
• Check pressure hose connecon from tub to pressure sensor. Is hose pinched, kinked, plugged, or leaking air?
• Onboard pressure transducer fault.
• Check for proper drain hose installaon. Is water siphoning out of the drain hose? Drain hose must not be more than 4.5”
(114 mm) into the drain pipe. Make sure drain hose is not seated into drain pipe, and that there is an air gap for venlaon.
Ensure drain height is between 39” (991 mm) and 8’ (2.4 m) above the oor.
• See TEST #2: Valves, page 3-7 and TEST #5: Water Level, page 3-13.
 F 8 E 4 1
Fault is displayed when the hot and cold inlet hoses are reversed.
• Make sure inlet hoses are connected correctly.
• See TEST #2: Valves, page 3-7.
 F 8 1 E 1
Fault is displayed when the water level does not change aer the drain pump is on for 10 minutes.
• Is the drain hose or the drain pump clogged? Check tub sump under impeller for obstrucons.
• Is the drain hose height greater than 8’ (2.4 m)?
• Too much detergent.
• Check pressure hose connecon from tub to pressure sensor. Is hose pinched, kinked, plugged, or leaking air?
• Is the pump running? If not, see TEST #6: Drain Pump, page 3-14.