Service Manual
Table Of Contents
- Service Manual - 27" Gas & Electric Stacked Laundry Center, L-95
- Table of Contents
- Section 1 - General Information
- Section 2 - Diagnostics & Troubleshooting
- Diagnostic Guide
- Diagnostic LED-Main Control
- Self Diagnostic Test Modes (Washer)
- Activating the Service Diagnostic Test Modes (Washer)
- Unsuccessful Entry
- Exiting the Service Diagnostic Test Modes (Washer)
- Customer Viewable Fault Codes (Washer)
- Fault/Error Codes Chart (Washer)
- Automatic Test Mode Chart (Washer)
- Manual Test Mode Chart (Washer)
- Washer Troubleshooting Guide
- Dryer Troubleshooting Guide
- Section 3 - Testing - Washer
- Section 4 - Testing - Dryer
- Section 5 - Component Access
- Product Specifications & Warranty Information Sources
3-4
n
27” Stacked Laundry Center
TESTING – WASHER
For Service Technician Use Only
WIRING DIAGRAM
3$*(
FOR SERVICE TECHNICIAN’S USE ONLY
DO NOT REMOVE OR DESTROY
Washer Wiring Diagram (1/3 or 1/4 HP motor, onboard pressure transducer,
3 or 4 rotary switches)
IMPORTANT: Electrostatic discharge may cause damage to machine control electronics. See page 1 for ESD information.
Figure 9 - Washer Wiring Diagram
L1
N
Power
Supply
2.5W
5 VDC
VCC
12 VDC
MAIN CONTROL
Line 1
Neutral
Ground
LEGEND
SHIFTER MOTOR (N)
–5VDC (CIRCUIT GND)
SHIFTER POSITION OUT
SHIFTER MOTOR (L1)
+12VDC
RPM OUT
LOCK SOLENOID
CCW
CW
790 - 840 W
790 - 840 W
EACH WINDING:
1/3HP MOTOR - 3.5 TO 6 W
1/4HP MOTOR - 5 TO 9.5 W
K4-MAIN RELAY
1
14 TO 25 W
ROTARY SWITCHES
K2-RELAY
NOT USED
NOT USED
IN CIRCUIT PROGRAMMING