Service Manual
Table Of Contents
- Service Manual - 27" Gas & Electric Stacked Laundry Center, L-95
- Table of Contents
- Section 1 - General Information
- Section 2 - Diagnostics & Troubleshooting
- Diagnostic Guide
- Diagnostic LED-Main Control
- Self Diagnostic Test Modes (Washer)
- Activating the Service Diagnostic Test Modes (Washer)
- Unsuccessful Entry
- Exiting the Service Diagnostic Test Modes (Washer)
- Customer Viewable Fault Codes (Washer)
- Fault/Error Codes Chart (Washer)
- Automatic Test Mode Chart (Washer)
- Manual Test Mode Chart (Washer)
- Washer Troubleshooting Guide
- Dryer Troubleshooting Guide
- Section 3 - Testing - Washer
- Section 4 - Testing - Dryer
- Section 5 - Component Access
- Product Specifications & Warranty Information Sources
COMPONENT ACCESS
27” Stacked Laundry Center
n
5-17
Reassembling the Dryer Assembly
To Reassemble the Dryer Assembly
IMPORTANT: The following steps must be performed by two
(2) people.
1. With two people, place dryer assembly on the washer and
dryer supports.
IMPORTANT:
• With two people, li up dryer assembly over the
washer—high enough to clear the water valve
assembly. See Figures 1 & 2.
• When placing the dryer assembly on the washer,
rst align the back of the dryer with the second
hole on the dryer support. See Figures 1 & 2.
NOTE: Make sure the intermediate harnesses do not
get pinched when placing the dryer on the washer.
• Slide dryer slowly back unl the two locaon “detents”
on the boom of the dryer align with the two holes on
the washer and dryer supports. See Figures 1 & 2.
• Thermal shield must be in front of water valve
assembly and behind the locang screw. NOTE: One
installer may need to p the dryer slightly for the other
to “push” the shield over the screw.
• If disconnected, reconnect harness to water valve.
2. With two people, one installing screws and the other
supporng the dryer, install one 5/16” screw per side
aaching dryer to triangle bracket. See Figure 8, page 5-15.
3. Next, install the remaining four (4) 5/16” screws per side
aaching dryer to washer. See Figures 6 & 7, page 5-15.
4. Reconnect the three harness connectors to the right of
the water inlet valve assembly (Water Valve/Lid Switch/
Motor & Shier Harnesses). See Figure 4, page 5-15.
5. Reconnect the pressure hose. See Figures 3, page 5-15.
6. Replace all remaining parts and panels.
WARNING
Excessive Weight Hazard
Use two or more people to move and install
washer/dryer.
Failure to do so can result in back or other injury.
WARNING
Electrical Shock Hazard
Disconnect power before servicing.
Failure to do so can result in death or
electrical shock.
Replace all parts and panels before operating.
WARNING
Electrical Shock Hazard
Disconnect power before servicing.
Failure to do so can result in death or
electrical shock.
Replace all parts and panels before operating.
Figure2-DryerBottomView(oneside)
Figure1-WasherTopView
Thermal Shield
Water Valve
Assembly
Valve Harness
Locang
Screw
Locaon Holes
Locaon Detents
Screw Locaons