Installation Instructions

16
Replace inlet hose after 5 years of use to reduce the risk
of hose failure. Periodically inspect and replace inlet hose
if bulges, kinks, cuts, wear, or leaks are found.
When replacing your inlet hose:
n Mark the date of replacement on the label with a
permanent marker.
n Check that the old washer is not stuck on the washer
inlet valve.
n Use a new washer in the new inlet hose to ensure a
proper seal.
WATER INLET HOSE
REMOVING THE LOAD & GO
™
BULK CONTAINER
To remove:
1. Lift the bulk container lid on the top of the washer/dryer.
2. Lift up on the bulk container handle and pull straight up
and out of the washer/dryer.
To replace:
1. Place the bulk container back into the bulk container
cavity on the top of the washer/dryer and make sure
that it is seated.
2. Close the bulk container lid.
If moving, or not using your washer/dryer for a period
of time, follow these steps:
1. Unplug or disconnect power to washer/dryer.
2. Turn off water supply to washer/dryer to avoid ooding
due to water pressure surges.
HELPFUL TIP: Attach a reminder note to the washer/
dryer to turn the water back on before washer’s next use.
3. Clean the bulk dispenser. See “Cleaning the Load & Go
™
Bulk Dispenser.”
NON-USE AND VACATION CARE
WINTER STORAGE CARE
IMPORTANT: To avoid damage, install and store washer/
dryer where it will not freeze. Because some water may stay
in hoses, freezing can damage washer/dryer. If storing or
moving during freezing weather, winterize your washer/dryer.
To winterize washer/dryer:
1. Shut off water faucet, disconnect and drain water
inlet hose.
HELPFUL TIP: Attach a reminder note to the washer/
dryer to turn the water back on before washer’s next use.
2. Remove drain pump lter.
3. Put 1 qt. (1 L) of R.V.-type antifreeze in drum and run
washer on Normal cycle for about 2 minutes to mix
antifreeze and remaining water.
4. Unplug washer/dryer or disconnect power.
The Clean Washer with affresh
®
message will ash at the end
of a wash cycle when the washer has run 30 wash cycles. This
is a reminder to run the Clean Washer with affresh
®
cycle.
If the Clean Washer with affresh
®
cycle is not run, the message
will stop ashing at the end of a wash cycle after running three
more regular wash cycles. After 30 more wash cycles are
completed, the Clean Washer with affresh
®
message will again
ash at the end of a wash cycle as a reminder.
CLEAN WASHER CYCLE REMINDER