Service Manual

COMPONENT ACCESS
Whirlpool Smart All-In-One Washer & Dryer
n
4-19
Removing the Drain & Recirculation Pumps
WARNING
Electrical Shock Hazard
Disconnect power before servicing.
Failure to do so can result in death or
electrical shock.
Replace all parts and panels before operating.
To Remove the Drain Pump & Recirculation Pumps
1. Unplug washer/dryer or disconnect power.
2. Turn o water supply to washer/dryer.
3. Disconnect cold inlet water hose and remove the drain
hose from the standpipe or laundry tub.
4. Remove the drain hose from its clips. Open drain hose to
drain any water remaining in the drain and recirculaon
pumps (see Figure 1).
5. Remove the four (4) Phillips screws securing the drain
pump to the front panel. See Figure 1.
NOTE: Recommend use of magnec pped screwdriver
when removing the four screws.
Remove
4 Screws
Unclip hose,
drain water.
Figure 1
6. Gently lay washer/dryer on its right side to access the
Drain and Recirculaon Pumps.
7. Disconnect all hose clamps and hoses from the drain and
recirculaon pumps (see Figure 2).
8. Disconnect the harness from both the drain and
recirculaon pumps. See Figure 2.
Disconnect
Hoses &
Harnesses
Drain Pump
Recirc. Pump
Figure 2
9. Remove pump assembly from washer/dryer. See Figure 3.
10. Reverse procedure to reinstall pumps.
Drain & Recirculation Pumps
Figure 3
Recirculaon
Pump
Drain Pump
Recirc.
Connector
Drain Connector