Service Manual

COMPONENT ACCESS
Whirlpool Smart All-In-One Washer & Dryer
n
4-9
Removing the Pressure Switch
WARNING
Electrical Shock Hazard
Disconnect power before servicing.
Failure to do so can result in death or
electrical shock.
Replace all parts and panels before operating.
To Remove the Pressure Switch
1. Unplug washer/dryer or disconnect power.
2. Turn o water supply to washer/dryer.
3. Disconnect cold inlet water hose and remove the drain
hose from the standpipe or laundry tub.
4. Perform the procedures on page 4-3, “Removing the Top
Panel” prior to performing the following steps.
5. The pressure switch is located on the right panel toward
the front.
6. Squeeze the pressure switch mounng clip to remove the
pressure switch from the side panel (see Figure 1).
Press inward on
Mounng Clips
Figure 1
7. Remove the hose from the pressure switch (see Figure 2).
8. Disconnect the pressure switch harness (see Figure
2.) Press the clip away from the harness and slide out
connector.
Remove
Hose
Disconnect
Connector
Hose
Port
Figure 2
9. Reverse procedure to reinstall pressure switch.