Dimensions

20
Location Requirements
Proper installation is your responsibility. Check code
requirements. Some codes limit, or do not permit, installing
washer/dryer in garages, closets, mobile homes, or sleeping
quarters. Contact your local building inspector.
You will need:
■ A separate 30 amp circuit.
■ A grounded electrical outlet located within 2 ft. (610 mm)
of either side of washer/dryer. See “Electrical Requirements.”
■ Water faucet located within 4 ft (1.2 m) of water ll valve
on washer/dryer, and water pressure of 20–100 psi
(137.9–689.6 kPa).
■ A level oor with maximum slope of 1" (25 mm) under entire
washer/dryer. Installing on carpet or surfaces with foam
backing is not recommended.
■ Floor must support washer/dryer’s total weight (with water
and load) of 400 lbs (180 kgs).
■ For garage installation, place washer/dryer at least 18"
(460 mm) above oor. If using a pedestal, you will need 18"
(460 mm) to bottom of washer/dryer.
IMPORTANT: Do not install, store, or operate washer/dryer where
it will be exposed to weather or in temperatures below 32°F (0°C).
Water remaining in washer/dryer after use may cause damage in
low temperatures. See “All-In-One Washer/Dryer Maintenance”
for winterizing information.
All dimensions show recommended spacing allowed, except for
closet door ventilation openings which are the minimum required.
For each arrangement, consider allowing more space for ease of
installation and servicing, and spacing for companion appliances
and clearances for walls, doors, and oor moldings.
Space must be large enough to allow door to fully open.
Add spacing of 1" (25 mm) on all sides of washer/dryer to
reduce noise transfer. If a closet door or louvered door is
installed, top and bottom air openings in door are required.
48
15
/16"
(1243 mm)
28"
(675 mm)
33
1
/4" Min.
(845 mm)
33
3
/4" Max.
(857 mm)
24"
(610 mm)