Installation Instruction

3-wire receptacle

(NEMA-type 10-30R)

3 prong plug

Spade terminals

with upturned ends

Ring terminals

4. Connect remaining wires

Connect remaining wires under outer terminal block screws.

Tighten screws and also tighten strain relief screws. Finally,

install terminal box cover and secure with the three screws.

Now, go to “Route Drain Hose.”

3-Wire Power Supply Cord Connection

Use where local codes permit connecting cabinet-ground

conductor to neutral wire.

2. Connect remaining wires

Connect remaining wires under outer terminal block screws.

Tighten screws and also tighten strain relief screws. Finally,

install terminal block cover and secure with the three screws.

Now, go to “Route Drain Hose.”

Connect neutral (center) wire (C) of power supply cord

under center terminal block screw (A)

. Tighten screw.

3-Wire Power Supply Cord Strain Relief:

IMPORTANT: Use the strain relief supplied with the washer/dryer.

Attach power supply cord to strain relief

Put power supply cord through the strain relief. Be sure

that the wire insulation on the power supply cord is inside

the strain relief. Do not further tighten strain relief screws

at this point.

Connect ground wire (D) (green or bare) of power supply

cord under green external ground conductor screw (B).

Tighten screw.

3. Connect ground wire

1. Connect neutral (center) wire