Installation Instruction

TROUBLESHOOTING

If you experience Possible Causes Solution

Drying Results (cont.)

Lint on load Drain pump lter is clogged with lint. Clean the drain pump lter. See “Cleaning the Drain Pump Filter/

Draining Residual Water.” This procedure should be performed

every 6 months.

Dried loads are wrinkled The load was not removed from

washer/dryer at the end of the drying

cycle.

Remove garments promptly at the end of the drying cycle,

or use the Wrinkle Shield

™

option (see “Using the All-In-One

Washer/Dryer”).

The washer/dryer was tightly packed. Dry smaller loads that can tumble freely. Loading drum half full

or less will improve drying performance and cycle time. Results

may also vary depending on fabric type.

Load too hot Load removed before cool-down

portion of cycle complete.

Allow the drying cycle to complete the cool-down portion of the

cycle before removing the load. If you cancel the cycle before

the cool-down portion of the cycle and immediately remove the

load, it will be very hot.

First try the solutions suggested here or visit our website at www.whirlpool.com/owners

(in Canada www.whirlpool.ca/owners) for assistance and to possibly avoid a service call.