Installation Instructions
18
REINSTALLING/USING
WASHER/DRYER AGAIN
To reinstall washer/dryer after non-use, vacation, winter
storage, or moving:
1.
Refer to “Installation Instructions” to locate, level, and
connect washer/dryer.
2.
Before using again, run washer/dryer through the
following recommended procedure:
To use washer/dryer again:
1.
Flush water pipes and hose. Reconnect water inlet
hose. Turn on water faucet.
2.
Plug in washer/dryer or reconnect power.
3.
Run washer/dryer through Heavy Duty wash cycle
to clean washer/dryer and remove antifreeze, if used.
Use only HE detergent. Use half the manufacturer’s
recommended amount for a medium-size load.
TRANSPORTING YOUR WASHER/DRYER
1. Shut off water faucet. Disconnect and drain water inlet
hose.
2. If washer/dryer will be moved during freezing weather,
follow “Winter Storage Care” directions before moving.
3. Disconnect drain hose from drain system and from back
of washer/dryer.
4. Unplug power cord.
5. Place inlet hose and drain hose inside drum.
6. Bundle power cord with a rubber band or cable tie
to keep it from hanging onto the ground.
IMPORTANT: Call for service to install new transport
bolts. Do not reuse transport bolts. Washer/dryer must
be transported in the upright position. To avoid structural
damage to your washer/dryer, it must be properly set up
for relocation by a certied technician.