Installation Instructions

42
If you experience Possible Causes Solution
Error Code Appears in Display
Once any possible issues are corrected, touch the POWER button once to clear the code. Re-select and restart the cycle.
F0E1
Load detected
in Clean Washer
with affresh
®
cycle
Items detected in the washer/dryer
when running a Clean Washer with
affresh
®
cycle.
Remove load and restart the Clean Washer with affresh
®
cycle.
F0E2
Oversuds detection
Excessive suds in washer/dryer.
Washer/dryer is running a suds
reduction routine. Allow the wash
cycle to continue.
Use only HE detergent.
F0E3
Over temperature
on dry cycle
Dryer fan not functioning properly. Try resetting the washer/dryer by unplugging it from the outlet
and then plugging it back in. If unsuccessful, call for service.
F0E4
Over temperature
on wash cycle
Wash water is too hot. Washer/dryer
may be connected incorrectly to the
home water supply.
Make sure that the washer/dryer is connected to the cold
water supply only.
F0E5
Off balance load
detected
Load could be unbalanced
or too large.
Avoid tightly packing the washer/dryer. Avoid washing single
items. Balance a single item with such as a rug or jeans with a
few extra items.
F1E4
Main relay error
Problem detected with the main relay. Try resetting the washer/dryer by unplugging it from the outlet
and then plugging it back in. If unsuccessful, call for service.
F3E1
Pressure sensor problem
Problem detected with the pressure
sensor.
Try resetting the washer/dryer by unplugging it from the outlet
and then plugging it back in. If unsuccessful, call for service.
F3E2
Wash NTC failure
Problem detected with the wash NTC. Call for service.
F3E3
Air inlet NTC failure
Problem detected with the air inlet
NTC. The wash function is still
operable, but the dry function will
not operate.
Call for service.
F3E4
ADS error – sensors
Detergent level sensor error. Clean the Load & Go
™
bulk detergent dispenser,
or add detergent manually until dispenser is cleaned.
F4E2
Dryer heater circuit failure
Problem detected with the dryer
heater circuit. The wash function
is still operable, but the dry function
will not operate.
Call for service.
F4E3
Dryer blower motor failure
Problem detected with the dryer
blower motor. The wash function is
still operable, but the dry function
will not operate.
Call for service.
F5E1
Door lock/door switch
problem
Problem detected with the door
switch/door lock. Door is unlocked
during a cycle when it should be
locked.
Try resetting the washer/dryer by unplugging it from the outlet
and then plugging it back in. If unsuccessful, call for service.
F5E2
Door lock will not lock
Problem detected with the door lock. Try resetting the washer/dryer by unplugging it from the outlet
and then plugging it back in. If unsuccessful, call for service.
F5E3
Door lock will not unlock
Problem detected with the door lock. Try resetting the washer/dryer by unplugging it from the outlet
and then plugging it back in. If unsuccessful, call for service.
TROUBLESHOOTING
First try the solutions suggested here or visit our website at www.whirlpool.com/owners
(in Canada www.whirlpool.ca/owners) for assistance and to possibly avoid a service call.