Service Manual

1-12
n
Whirlpool Smart All-In-One Washer & Dryer
GENERAL INFORMATION
Cleaning the Drain Pump Filter/Draining Residual Water
16
3. Lay a cotton cloth beneath the drain pump  lter to absorb
any water still in it. Then remove the drain pump  lter by
turning it counterclockwise.
4. Remove large clumps of lint by hand from the  lter and
place lint in a suitable waste container. Remove remaining
residue from the  lter by rinsing with water.
5. Reinsert the drain pump  lter by turning it clockwise.
Make sure to turn it in as far as it will go, with the  lter
handle left in a vertical position.
CLEANING THE DRAIN PUMP FILTER/
DRAINING RESIDUAL WATER (cont.)
CLEANING THE DRAIN PUMP FILTER/
DRAINING RESIDUAL WATER
1.
Open the drain pump 
lter access door at the bottom right
corner at the front of the washer/dryer.
2.
Place a broad,  at container beneath the drain pump  lter
to collect the drain water. Pull out the black hose, remove
the plug, and drain the hose into the container. Empty
the container. Repeat this procedure if necessary until all
the water has drained. Make sure that the black hose is
completely dry.
NOTE: Perform the following procedure every 6 months.
Black hose
Cleaning the Drain Pump Filter/
Draining Residual Water
16
3. Lay a cotton cloth beneath the drain pump  lter to absorb
any water still in it. Then remove the drain pump  lter by
turning it counterclockwise.
4. Remove large clumps of lint by hand from the  lter and
place lint in a suitable waste container. Remove r
emaining
residue from the  lter by rinsing with water.
5. Reinsert the drain pump  lter by turning it clockwise.
Make sure to turn it in as far as it will go, with the  lter
handle left in a vertical position.
CLEANING THE DRAIN PUMP FILTER/
DRAINING RESIDUAL WATER (cont.)
CLEANING THE DRAIN PUMP FILTER/
DRAINING RESIDUAL WATER
1. Open the drain pump  lter access door at the bottom right
corner at the front of the washer/dryer.
2. Place a broad,  at container beneath the drain pump  lter
to collect the drain water. Pull out the black hose, remove
the plug, and drain the hose into the container. Empty
the container. Repeat this procedure if necessary until all
the water has drained. Make sure that the black hose is
completely dry.
NOTE: Perform the following procedure every 6 months.
Black hose
WARNING
Electrical Shock Hazard
Disconnect power before cleaning.
Replace all parts and panels before operating.
Failure to do so can result in death or electrical shock.