Service Manual

4-2

Whirlpool Smart All-In-One Washer & Dryer

COMPONENT ACCESS

Remove HMI

Connector Bag

Figure 2

Figure 3 - Connector Bag

5. Remove tape and bag, and disconnect HMI connector (see

Figure 4). Preserve the tape and bag for reassembly.

HMI

Connector

Figure 4

6. Using a 10 mm hex head driver,

remove three (3) hinge screws.

See Figure 5 at right.

7. Li up on door assembly and

remove.

8. Reverse procedure to reinstall.

Be sure to reinstall the HMI

connector bag and tape.

Figure 5

Removing the Door Assembly

WARNING

Electrical Shock Hazard

Disconnect power before servicing.

Failure to do so can result in death or

electrical shock.

Replace all parts and panels before operating.

To Remove the Door Assembly

1. Unplug washer or disconnect power.

2. Open door and remove the two (2) hinge screw covers

illustrated in Figure 1.

Figure 1

3. Using a Phillips screwdriver, remove the two door hinge

cover screws. Remove door hinge cover and set aside.

4. Pull out the HMI connector bag from below door hinge

(see Figure 2 & 3). (The bag is “tucked-away” between

the hinge and front panel.) Remove tape and bag, and

disconnect HMI connector. Preserve the tape and bag for

reassembly.

Remove 3

Hinge Screws