Specifications

ManualsBrandsWhirlpool ManualsFurnaceWFD193

Upright Installations

Depending on the installation and/or customer preference, filters

can be installed in the central return register or a side panel

external filter rack kit (upflows). As an alternative a media air filter

or electronic air cleaner can be used as the requested filter.

Filter Locations—Possible Upright Upflow

Filter Locations—Possible Upright Counterflow

Horizontal Installations

Filters must be installed in either the central return register or in

the return air ductwork.

Make Electrical Connections

Thermostat

NOTE: Wire routing must not interfere with circulator blower

operation, filter removal, or routine maintenance.

Low voltage connections can be made through either the right-

hand or left-hand side panel. Thermostat wiring entrance holes

are located in the lower compartment. Refer to “Thermostat

Diagram” for thermostat connections to the integrated control

module terminal strip.

Thermostat Diagram

This furnace is equipped with a 40 VA transformer to facilitate use

with most cooling equipment. Consult the wiring diagram located

on the blower compartment door for further details of 115-volt

and 24-volt wiring.

1. Disconnect power.

2. Remove the screw from the furnace electrical connection

box.

A. Central return grille

B. Filter

C. Airflow

D. Side return external filter rack kit

(either side)

A. Filter access door

B. Filter

C. Central return grille

D. Airflow

E. Filter support bracket (provided)

F. Retur n d uct

A. Heating room thermostat

B. Furnace

C. Heating and cooling room thermostat

D. Remote condensing unit

Goodman 70

To avoid the risk of electrical shock, wiring to the unit

must be polarized and grounded.

WARNING

Goodman 6

HIGH VOLTAGE!

WARNING

Disconnect ALL power before servicing.

Multiple power sources may be present.

Failure to do so may cause property damage,

personal injury or death.

Goodman 56

Edges of sheet metal holes may be sharp. Use gloves as

a precaution when removing hole plugs.

WARNING

Goodman 59

Label all wires prior to disconnection when servicing

controls.

Wiring errors can cause improper

and

dangerous

operation. Verify proper operation after servicing.

CAUTION