INSTALLATION INSTRUCTIONS 3(}"(76.2CM)FREESTANDINGGASRANGE with standard clean oven Table of Contents .................................................. 2 IMPORTANT: Save for local electrical inspector's use.
TABLEOF CONTENTS RANGE SAFETY .......................................................................... 2 iNSTALLATiON REQUIREMENTS .............................................. Tools and Parts .......................................................................... 4 4 Location Requirements .............................................................. 4 Electrical Requirements ............................................................ 6 Gas Supply Requirements ..............................
WARNING: may result If the information causing property in this manual is not followed e×actly, a fire or e×plosion damage, personal injury or death. = Do not store or use gasoline or any other appliance. or other flammable = WHAT GAS: TO DO IF YOU SMELL vapors and liquids in the vicinity of this = Do not try to light any appliance. • Do not touch any electrical switch. = Do not use any phone in your building. • Immediately instructions.
INSTALLATIONREQUIREMENTS Gather the required tools and parts before starting installation. Read and follow the instructions provided with any tools listed here. Tools Level [] 3/8"drive ratchet [] [] Tape measure Flat-blade screwdriver [] [] Phillips screwdriver Hand or electric drill [] Slip-joint pliers [] 7 mm combination wrench [] Pipe wrench [] 1/8"(3.2 mm) drill bit (for wood floors) [] 8/18"(4.
Product installation Dimensions Clearances Cabinet opening dimensions shown are for 25" (64 cm) countertop depth, 24" (61 cm) base cabinet depth and 36" (91.4 cm) countertop height. If the cabinet depth is greater than 24" (61 cm), the oven frame must extend beyond cabinet fronts by 1/2"(13 mm) minimum. 26-3/4" (67.9 Crn) ©© ©© b ° handle _top ght !"crn/ 46-1/4" (117.5 crn) overall height for tall backguard models /_ 30-1/8" (76.5 crn) I see NOTE. opening width 1 18"(45.7crn) rnin.
Electrical Shock Hazard Explosion Hazard Plug into a grounded 3 prong outlet. Use a new CSA International Do not remove Install ground prong. a shut-off Securely Do not use an extension cord. If connected to LP, have a qualified person make sure gas pressure does not exceed 14" (36 cm) water column. can result in death, all gas connections. This range is equipped with an electronic ignition system that will not operate if plugged into an outlet that is not properly polarized.
Flexible metalappliance connector: [] Iflocalcodes permit,anewCSAdesign-certified, 4-5ft (122-152.4 cm)long,1/2" (1.3cm)or3/4" (1.9cm)I.D.,flexible metalappliance connector maybeusedforconnecting range tothegassupply line. [] A1/2" (1.3cm)malepipethread isneeded forconnection to thefemale pipethreads oftheinlettotheappliance gas pressure regulator. [] Donotkinkordamage theflexible metaltubingwhenmoving therange.
INSTALLATIONINSTRUCTIONS Before moving range, slide range onto shipping base, cardboard or hardboard. 1. Remove template from the anti-tip bracket kit (found inside the oven cavity). Excessive Weight Hazard Use two or more people to move and install range. Failure to do so can result in back or other injury. 2. Place template on the floor in the cabinet opening so that the left edge is against the cabinet and the top edge is against the rear wall, molding or cabinet. 3. Tape template in place. 4.
10. Adjust the leveling legs to the correct height. Leveling legs can be loosened to add up to a maximum of 1" (2.5 cm). A minimum of 3/16" (5 mm) is needed to engage the anti-tip bracket. 11. Move the range into final position making sure the rear leveling leg slides into the anti-tip bracket. Typical rigid pipe connection A combination of pipe fittings must be used to connect the range to the existing gas line. Your connections may be different, according to the supply line type, size and location. 1.
Complete Connection 1. Locate gas pressure regulator in the broiler. Electronic Ignition System Cooktop and oven burners use electronic ignitors in place of standing pilots. When a cooktop control knob is turned to the "LITE" position, the system creates a spark to light the burner. This sparking continues until the control knob is turned to the desired setting. A. Gaspressure regulat or IMPORTANT: Do not remove the gas pressure regulator. 2.
3, Replace control knob. 3. Locate the air shutter near the rear wall of oven and loosen the shutter screw. CheckOperationof Oven/BroilBurner 1, Openbroiler door. 2. Pressthe"BAKE" pad. [] The"BAKE" indicator willlight. [] "350"willappear inthedisplay. 3, PresstheSTART/ENTER pad. [] The"TEMP" and"ON"indicators willappear. [] Thedisplay willshowtheautomatic countdown time (10minutes) needed topreheat theovenforselected temperature. [] Theovenburner should lightin20-40seconds; thisdelay isnormal.
GASCONVERSIONS Unplug or disconnect power. 3. 2. Open broiler door and remove broiler pan. The gas pressure regulator is located in the back right hand corner of the broiler compartment. Explosion Hazard Use a new CSA International approved gas supply line. Install a shut-off valve. Securely tighten A.Gaspressureregulator all gas connections. IMPORTANT: Do not remove the gas pressure regulator.
2. Locate LP gas orifice spuds for top burners in the bag containing literature included with the range. Three LP gas spuds are stamped "88" and one "96." 3. Remove natural gas orifice spuds using a 7mm combination wrench. 4. Install LP gas orifice spuds. NOTE: Depending on model, the range cooktop may be equipped with 4 standard burners or 3 standard burners and 1 power burner. Spud size/location remain the same. To Convert Oven Burner 1.
5. Turn the cap over so that N or NAT is visible. A A. Cap 6. Reinstall the cap. Tip Over Hazard To Convert A child or adult can tip the range and be killed, Connect anti=tip bracket to rear range foot. Reconnect the anti=tip bracket, 1. Surface Burners Remove burner grates, burner caps, and burners. if the range is moved. Failure to follow these instructions can result in death or serious burns to children and adults. To Convert Gas Pressure Regulator ................S 1.
Install natural gasorificespuds. NOTE: Depending onmodel, therangecooktop maybe equipped with4 standard burners or3 standard burners and 1 >ower burner. Spudsize/location remain thesame. To Convert Oven Burner 1. Open oven door and remove oven racks, oven tray, flame spreader and set aside. 2. Lift oven burner. The orifice spud is behind the oven burner air shutter. 3. Locate natural gas orifice spud stamped "47" in literature package supplied with range. Std burner 149 Std bumer 149 c_,c, ' ......
W10032050 @2006 Whirlpool Corporation All rights reserved.
