Specification

7
ELECTRONIC OVEN CONTROL
Tones
Tones are audible signals, indicating the following:
One tone
■ Valid pad press
■ Oven is preheated (long tone)
■ Function has been entered
Three tones
■ Invalid pad press
■ Push to start reminder
Cycling tones
■ End of cycle
Fahrenheit and Celsius
The temperature is preset at Fahrenheit, but can be changed to
Celsius.
To Change: Press and hold Broil for 5 seconds. A tone will
sound, and “C” will appear on the display. Repeat to change
back to Fahrenheit. To exit mode, press CANCEL or wait
3 seconds.
Timer
The timer can be set in hours or minutes up to 12 hours and
59 minutes, and counts down the set time either in hours and
minutes, or in minutes and seconds. The timer does not start or
stop the oven.
To Set:
1. Press Timer Set/Off. The timer indicator light will light up.
2. Press the Temp/Time “up” or “down” arrow pads to set the
length of time.
3. Press START. When the set time ends, end-of-cycle tones will
sound.
4. Press Timer Set/Off pad twice anytime to cancel the timer and
reminder tones.
If CANCEL is pressed, the oven will turn off and the cook function
will be disabled.
To display the time of day for 5 seconds when the timer is counting
down, press Clock.
If START is not pressed within 5 seconds after pressing Timer
Set/Off or Temp/Time arrow pads, the “PSH” indicator light will
flash and the push to start tone will sound as a reminder. If no
action is taken after 1 minute, the display will return to the time of
day or bake or broil mode.
The timer can be reprogrammed to change the time while it is
running.
To Reprogram:
Oven Indicator Lights
The indicator lights are located on both sides of the display. The
indicator lights light up or flash when the oven is in one of the
following modes: Bake, Broil or Timer.
Start
START begins any oven function. If START is not pressed within
5 seconds after pressing a function pad, the Push to START
(“PSH”) indicator light will flash and the push to start tone will
sound as a reminder.
If START is not pressed within 1 minute after pressing a function
pad, the oven display will return to the time of day mode and the
programmed function will be canceled.
Cancel
CANCEL stops any function except the Clock, Timer,
and Control Lock.
1. Press Clock.
2. Press the Temp/Time “up” or “down” arrow pads to set the
time of day.
3. Press Clock or START.
1. Press Timer Set/Off.
2. Press the Temp/Time “up” or “down” arrow pads to
adjust time.
3. Press START.
When power is first supplied to the appliance, a flashing time will
appear on the display. Press Cancel to clear flashing time from
the display.
If flashing time appears, a power failure has occurred. Press
Cancel and reset the clock if needed.
When the oven is not in use, the display shows the time of day.
When performing a cook or timer function, the display will show
either hours and minutes, or minutes and seconds.
Display
This is a 12 hour clock and does not show a.m. or p.m.
To Set:
Before setting, make sure the oven and Timer are off. Press
CANCEL to cancel the oven, and press Timer Set/Off twice
to cancel the timer.
Clock