Installation Instructions

14
7. Replace burner cap.
8. Repeat steps 1-7 for the remaining burners.
To Convert Oven Bake Burner (Natural Gas to
Propane Gas)
1. Remove the oven racks.
2. The oven burner orice is located beneath the in-let to the
oven burner at the lower rear portion of the broiler section.
Using a 1/2" wrench turn the orice hood clockwise to fasten
the hood on the orice pin about two complete turns.
NOTE: Do not over-tighten the orice hood.
Complete Installation (Natural Gas to Propane Gas)
1. Refer to the “Make Gas Connection” section for properly
connecting the range to the gas supply.
IMPORTANT: You may have to adjust the “LO” setting for
each cooktop burner.
Checking for proper cooktop, bake and broil burner ame
is very important. The small inner cone should have a very
distinct blue ame ¼" (0.64 cm) to ½" (1.3 cm) long. The
outer cone is not as distinct as the inner cone. Propane gas
ames have a slightly yellow tip.
2. Refer to “Complete Installation” in the “Installation
Instructions” section of this manual to complete this
procedure.
NOTE: Save the orices removed from the appliance for
future use.
3. After the above conversion has been completed, check
operation of cooktop and oven burner. Make air shutter
adjustments in oven if necessary.
Adjust Air Shutters
The air shutter adjustment for the oven burner is located at the
open end of the oven burner venture tube and sits on the hood
of the oven burner valve. To adjust air shutter:
1. Loosen the screw on the air shutter.
2. Move the air shutter closed to decrease or open to in- crease
the amount of air to the ame.
3. When the ame is properly adjusted, tighten the screw.
NOTE: The burner ame should be a steady blue. A burner
with a yellow ame, un-steady ame, or a partial ame is in
need of an air shutter adjustment.
Natural Gas Conversion
1. Turn the manual shutoff valve to the closed position.
2. Unplug range or disconnect power.
Orifice Hood
Propane Gas
Natural Gas
Pin
WARNING
Tip Over Hazard
A child or adult can tip the range and be killed.
Install anti-tip bracket to floor or wall per installation
instructions.
Slide range back so rear range foot is engaged in the
slot of the anti-tip bracket.
Re-engage anti-tip bracket if range is moved.
Do not operate range without anti-tip bracket installed
and engaged.
Failure to follow these instructions can result in death
or serious burns to children and adults.
A
B
C
A. To range
B. Manual shutoff valve “closed” position
C. Gas supply line