Installation Instructions

8
Install Anti-Tip Bracket
1. Remove the anti-tip bracket from inside the literature bag
assembly located in the oven.
2. Determine which mounting method to use: oor or wall.
If you have a stone or masonry oor, you can use the wall
mounting method. If you are installing the range in a mobile
home, you must secure the range to the oor.
3. It is necessary to determine the nal location of the range
before you can locate the anti-tip bracket. If the range is
going to be located between cabinets, place the bracket so
that Edge A sits at against the rear wall. Edge B should just
touch the side of the cabinet sitting to the right side of the
range.
If there are no adjacent cabinets, align Edge B of the bracket
with the edge of the range side. After the bracket has been
placed mark the hole locations with a marker.
4. The anti-tip bracket can be attached to the oor or the wall.
For wall mount application use Location C. When using
location C, the screws must penetrate the wall sill plate
located within the wall. For oor mount application use
Location D or E. One screw on each side of the bracket is
sufcient.
5. To mount anchor bracket to concrete or ceramic oor, use
a drill with a 3/16" masonry bit to drill the two holes. Tap
plastic anchor into mounting holes in oor with hammer.
Line up holes in anti-tip bracket to holes in oor. Use the two
screws provided to fasten anti-tip bracket to oor.
6. Unscrew the rear leg levelers approximately 1/2" so that the
rear leg levelers will slide in under the anti-tip bracket. Slide
range into the nal position after completing the gas and
electrical connections to the range.
Make Gas Connection
Typical exible connection
1. Apply pipe-joint compound made for use with Propane gas
to the smaller thread ends of the exible connector adapters
(see B and G in the following illustration).
2. Attach one adapter to the gas pressure regulator and
the other adapter to the gas shutoff valve. Tighten both
adapters.
3. Use a ¹
5
16
" (2.4 cm) combination wrench and adjustable
wrench to attach the exible connector to the adapters.
Check that connector is not kinked.
WARNING
Tip Over Hazard
A child or adult can tip the range and be killed.
Install anti-tip bracket to floor or wall per installation
instructions.
Slide range back so rear range foot is engaged in the
slot of the anti-tip bracket.
Re-engage anti-tip bracket if range is moved.
Do not operate range without anti-tip bracket installed
and engaged.
Failure to follow these instructions can result in death
or serious burns to children and adults.
Edge A
Edge B
Anti-Tip Bracket
Location C
Location D
Location E
Location C
WARNING
Explosion Hazard
Use a new CSA International approved gas supply line.
Install a shut-off valve.
Securely tighten all gas connections.
If connected to propane, have a qualified person make
sure gas pressure does not exceed 14" (36 cm) water
column.
Examples of a qualified person include:
licensed heating personnel,
authorized gas company personnel, and
authorized service personnel.
Failure to do so can result in death, explosion, or fire.
A
B
C
D
H
G
E
F
A. Gas pressure regulator
B. Use pipe-joint compound.
C. Adapter (must have ½" [1.2
cm] male pipe thread)
D. Flexible connector
E. Manual gas shutoff valve
F. ½" (1.2 cm) or ¾" (1.9 cm) gas
pipe
G. Use pipe-joint compound.
H. Adapter