Installation Instruction

15
To Convert Gas Pressure Regulator (Propane Gas to
Natural Gas)
1. Move the range to be able to work on the back of the unit.
2. Locate gas pressure regulator at the top right corner of the
back of unit.
IMPORTANT: Do not remove the gas pressure regulator.
3. Remove the cap from the gas pressure regulator using a 7/8"
(2.2 cm) wrench.
NOTE: Be sure sealing washer remains in the same position.
NOTE: Do not remove the spring beneath the cap.
4. To convert to propane gas, turn over the pin and place it
back on the cap.
5. Reinstall the cap.
To Convert Surface Burners (Propane Gas to Natural
Gas)
1. Remove burner cap.
2. Remove burner base.
3. Gas orice spuds are stamped with a number on the side.
Replace the Propane gas orice spud with the correct
Natural gas orice spud.
Refer to the following chart for the correct Natural gas orice
spud placement.
Natural Gas Orice Spud Chart
Burner Rating Size
15,000 BTU
1.80 mm
6,000 BTU
1.12 mm
9,100 BTU
1.35 mm
12,000 BTU 1.60 mm
NOTE: Refer to the Model Number and Serial Number Plate
located under the broiler carriage for proper sizing of spuds for
each burner location.
4. Place Propane gas orice spuds in plastic parts bag for
future use and keep with package containing literature.
5. Replace the burner.
6. Replace burner cap.
7. Repeat steps 1-7 for the remaining burners.
WARNING
Excessive Weight Hazard
Use two or more people to move and install range.
Failure to do so can result in back or other injury.
A
A. Gas pressure regulator
A
C
B
180 º
A. Cap
B. Sealing washer
C. Pin
A
B
A. Burner cap
B. Burner base
XX
A
A. Stamped number