Owners Manual
12
TROUBLESHOOTING
First try the solutions suggested here. If you need further assistance or more recommendations that may help you avoid a service call, refer
to the warranty, or visit www.whirlpool.com/product_help.
In Canada, visit http://www.whirlpool.ca.
Contact us by mail with any questions or concerns at the address below:
In the U.S.A.:
Whirlpool Brand Home Appliances
Customer eXperience Center
553 Benson Road
Benton Harbor, MI 49022-2692
Please include a daytime phone number in your correspondence.
In Canada:
Whirlpool Brand Home Appliances
Customer eXperience Centre
200 - 6750 Century Ave.
Mississauga, Ontario L5N 0B7
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
WARNING
PROBLEM POSSIBLE CAUSES SOLUTIONS
Nothing will operate Power supply cord is unplugged. Plug into a grounded 3 prong outlet.
Household fuse is blown or a
circuit breaker is tripped.
Replace the fuse or reset the circuit breaker. If the problem
continues, call an electrician.
Main or regulator gas shutoff
valve is in the off position.
See the Installation Instructions.
The range is improperly
connected to the gas supply.
Contact a trained repair specialist or see Installation
Instructions.
Surface burners will not
operate
The control knob is not set
correctly.
Push in knob before turning to a setting.
Air in the gas lines. If this is the rst time the surface burners have been used, turn
on any one of the surface burner knobs to release air from the
gas lines.
Clogged burner ports. See “Sealed Surface Burners” section.
Surface burner ames are
uneven, yellow and/or noisy
Clogged burner ports. See “Sealed Surface Burners” section.
Burner caps positioned
improperly.
See “Sealed Surface Burners” section.
Range converted improperly. If propane gas is being used, contact a service technician or
see cover for contact information.
To Replace:
Before replacing the bulb, make sure the oven is off and cool.
1. Unplug range or disconnect power.
2. Unscrew the oven light globe then grasp the halogen bulb and
pull out.
3. Replace bulb, using tissue or wearing cotton gloves to handle
bulb. To avoid damage to or decreasing the life of the new bulb,
do not touch bulb with bare ngers.
4. Replace oven light globe by screwing it back into place
.
5. Reconnect power.