Owners Manual

16
Oven Light
The oven lights are 120 V, 40 W maximum halogen bulbs. They will
come on when the oven door is opened. The oven lights will not
work during the Self-Cleaning cycle.
When the door is closed, touch the appropriate Oven Light keypad
to turn on the oven light.
To Replace:
Before replacing the bulb, make sure the oven is off and cool.
1. Unplug range or disconnect power.
2. Unscrew the oven light globe then grasp the halogen bulb and
pull out.
3. Replace bulb, using tissue or wearing cotton gloves to handle
bulb. To avoid damage to or decreasing the life of the new
bulb, do not touch bulb with bare ngers.
4. Replace oven light globe by screwing it back into place.
5. Reconnect power.
TROUBLESHOOTING
First try the solutions suggested here. If you need further assistance or more recommendations that may help you avoid a service
call,refer to the warranty, or visit producthelp.whirlpool.com. InCanada, visit www.whirlpool.ca.
Contact us by mail with any questions or concerns at the address below:
In the U.S.A.:
Whirlpool Brand Home Appliances
Customer eXperience Center
553 Benson Road
Benton Harbor, MI 49022-2692
In Canada:
Whirlpool Brand Home Appliances
Customer eXperience Centre
200 - 6750 Century Ave.
Mississauga, Ontario L5N 0B7
Please include a daytime phone number in your correspondence.
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
WARNING
Problem Possible Causes Solutions
Nothing will
operate
Power supply cord is unplugged. Plug into a grounded 3 prong outlet.
Energy Save is active,
andthedisplayisblank.
Press any keypad on the control to display the time of day. See the
“Electronic Oven Controls” section for more information.
Household fuse is blown or
acircuitbreakeristripped.
Replace the fuse or reset the circuit breaker. If the problem continues,
call an electrician.
Main or regulator gas shut-off valve
isintheOffposition.
See the Installation Instructions.
The range is improperly
connectedtothegassupply.
Contact a trained repair specialist or see the Installation Instructions.
Surface
burners will not
operate
The control knob is not set correctly. Push in knob before turning to a setting.
Air in the gas lines. If this is the rst time the surface burners have been used, turn on any
one of the surface burner knobs to release air from the gas lines.
Clogged burner ports. See the “Sealed Surface Burners” section.
Surface burner
ames are
uneven, yellow
and/or noisy
Clogged burner ports. See the “Sealed Surface Burners” section.
Burner caps positioned improperly. See the “Sealed Surface Burners” section.
Range converted improperly. If propane gas is being used, contact a service technician.
Excessive
heat around
cookware on
cooktop
Cookware and ame are not matched. The cookware should be centered above the burner with the bottom
sitting level on the grate. The ame should be adjusted so that it does
not extend up the sides of the pan.