Owners Manual

6
COOKTOP USE
Electric igniters automatically light the surface burners when
control knobs are turned to Ignite.
Before setting a control knob, place lled cookware on the
grate. Do not operate a burner using empty cookware or without
cookware on the grate.
The ame should be adjusted so it does not extend beyond the
edge of the pan.
To Set:
1. Push in and turn knob counterclockwise to IGNITE.
All surface burners will click. Only the burner with the control
knob turned to Ignite will produce a ame.
2. Turn knob to anywhere between High and Low.
Power™ Burner Feature
The front burner is designed to give maximum power when fully
on. It can be used to rapidly bring liquid to a boil and to cook large
quantities of food.
AccuSimmer
®
Burner Feature
The AccuSimmer
®
feature allows for more precise simmering and
low temperature cooking. It is the right rear burner.
Power Failure
In case of prolonged power failure, the surface burners can
be lit manually. Hold a lit match near a burner and turn knob
counterclockwise to IGNITE. After burner lights, turn knob to
setting.
Sealed Surface Burners
IMPORTANT: Do not obstruct the ow of combustion and
ventilation air around the burner grate edges.
Burner cap: Always keep the burner cap in place when using a
surface burner. A clean burner cap will help avoid poor ignition and
uneven ames. Always clean the burner cap after a spillover and
routinely remove and clean the caps according to the “General
Cleaning” section.
Alignment: Be sure to align the gas tube opening in the burner
base with the orice holder on the cooktop and the igniter
electrode with the notch in the burner base.
Gas tube opening: Gas must ow freely throughout the gas tube
opening for the burner to light properly. Keep this area free of soil,
and do not allow spills, food, cleaning agents, or any other
material to enter the gas tube opening. Keep spillovers out of the
gas tube by always using a burner cap.
Burner ports: Check burner ames occasionally for proper size
and shape as shown in the previous illustration. A good ame
is blue in color, not yellow. Keep this area free of soil and do not
allow spills, food, cleaning agents, or any other material to enter
the burner ports.
WARNING
Fire Hazard
Do not let the burner flame extend beyond the edge of
the pan.
Turn off all controls when not cooking.
Failure to follow these instructions can result in death
or fire.
REMEMBER: When range is in use, the entire cooktop area
may become hot.
D
E
C
B
A
A. Burner cap
B. Burner base
C. Alignment pins
D. Igniter
E. Gas tube opening
B
A
A. 1-1
1
/
2
" (2.5-3.8 cm)
B. Burner ports
Keypad Feature Instructions
CONTROL
LOCK
Oven and cooktop
control lockout
1. Check that the oven and cooktop are off.
2. Press and hold CONTROL LOCK for 3 seconds. A tone will sound and a lock icon will be
displayed.
3. Repeat to unlock. No keypads will function with the controls locked.
NOTE: The control lock cannot be activated or deactivated while the Hot Surface indicator
light is on. Wait for the Hot Surface indicator light to turn off before activating or deactivating
the control lock.
AQUALIFT
SELFCLEAN
Clean cycle See the “Clean Cycle” section.
B
A
E
D