Installation Instruction

21
To Convert Oven Broil Burner (Propane Gas to
Natural Gas)
1. Remove the screw from the broil burner.
2. Remove the flame spreader.
3. Remove the broil burner from the broil burner orifice hood.
NOTE: The broil burner will hang in the back of the oven
while changing the orifice hood.
A. Broil burner
B. Screws
C. Orifice hood
4. Use a 3/8" (9.5 mm) combination wrench and turn the
propane gas broil burner orifice hood counterclockwise to
remove. The hood will be stamped with a “100.”
5. Replace the “100” hood with a “155” hood. Install the
Natural gas broiler burner orifice hood, turning it clockwise
until snug.
IMPORTANT: Do not overtighten.
A. Orifice hood
6. Place the broil burner on the broil burner orifice hood and
insert the broil burner ceramic igniter in the hole in the rear of
the oven.
7. Position the broil burner against the top of the oven and
attach it with two screws.
8. Replace storage drawer or warming drawer. See the
“Storage Drawer” or “Warming Drawer or Premium Storage
Drawer” section.
9. Replace the oven door. See the “Oven Door” section.
10. Replace the oven racks.
x.xx
A
A
B
C
Complete Installation (Propane Gas to Natural Gas)
1. Refer to the “Make Gas Connection” section for properly
connecting the range to the gas supply.
2. Refer to the “Electronic Ignition System” section for proper
burner ignition, operation, and burner flame adjustments.
IMPORTANT: You may have to adjust the “LO” setting for
each cooktop burner.
Checking for proper cooktop, bake and broil burner flame is
very important. Natural gas flames do not have yellow tips.
3. Refer to “Complete Installation” in the “Installation
Instructions” section of these instructions to complete this
procedure.
NOTE: Make sure to save the orifices that have just been
replaced in the conversion.