Installation Instructions

9. Place a level on top of the All-In-One Washer and Dryer and

ensure that it is level from front to back and side to side.

10. Adjust the feet so that the rubber pads extend just below

the bottom of the pedestal and keep the pedestal at least

1/8" (3.175 mm) off the oor.

NOTE: For more stability, do not raise the bottom of the

pedestal any higher than necessary to clear the oor on

all four sides.

To adjust the All-In-One Washer and Dryer feet:

n Use a 11/16" (17 mm) open-end wrench to loosen the

locknut.

n Adjust the All-In-One Washer and Dryer feet up or down.

Be sure to completely tighten the locknuts again after

the All-In-One Washer and Dryer is level.

11. Follow the Installation Instructions that came with your

model to nish installing or reinstalling your All-In-One

Washer and Dryer.