Installation Instructions

2
Location Requirements
Parts supplied:
Remove parts from package. Check that all parts were included.
Metal pedestal
Tools required:
5/8" (16 mm) open-end
wrench (for bolts) and
11/16" (17 mm) open-end
wrench (for foot locknuts)
Level
Tools and Parts
Check that you have the tools and parts necessary
for correct installation.
INSTALLATION REQUIREMENTS
Bolts (4)
If the All-In-One Washer and Dryer with pedestal assembly
is located in a garage, 6" (152 mm) must be added under
the pedestal so that the All-In-One Washer and Dryer is 18"
(460 mm) above the garage oor. A separate riser, able to
support at least 275 lbs. (125 kg), may be required. The entire
pedestal must sit completely on the riser.
Before Installing Your Pedestal
IMPORTANT: If your All-In-One Washer and Dryer is already
installed, it must be uninstalled.
If you need to uninstall your All-In-One Washer and Dryer, see
the Installation Instructions that came with your model for tools
required.
Uninstalling Your All-In-One Washer and Dryer
1. Unplug the power supply cord.
2. Turn off the cold water faucet.
3. Slowly loosen the ll hose at the faucet to relieve the water
pressure. Use a sponge or towel to absorb the released water.
4. Pull the All-In-One Washer and Dryer away from the wall so
the pedestal can be placed in its nal location.