Instruction for Use

PAGE 2
FOR SERVICE TECHNICIAN’S USE ONLY
DO NOT REMOVE OR DESTROY
CONTROL PANEL (buttons to use when entering Service Diagnostic Mode/Service Test Cycle)
Cycle selector knob
1. POWER button: press and hold until display turns on
(indicator above the Program button lights. The indicators
above all the buttons scroll from left to right as the washer
turns on. Symbols appear on the control panel and
sounds are played).
3. START/PAUSE button:
press and hold to run
Service Test Cycle.
Figure 1 - User Interface
2. DELAY WASH and OPTIONS buttons: press DELAY WASH
4 times within 5 seconds while pressing and holding
OPTIONS button to enter Service Diagnostic Mode.