Instruction for Use

PAGE 6
FOR SERVICE TECHNICIAN’S USE ONLY
DO NOT REMOVE OR DESTROY
FAULT/ERROR CODES
(Refer to Fault/Error code charts
on pages 7–13.)
Fault/Error Code Display Method
Fault codes are displayed by showing
F##. The F## indicates the suspect
system/category or component.
Up to four Fault/Error codes may be stored.
In Service Diagnostic Mode, pressing START
displays the next saved Fault/Error Code.
If the display shows “F - -”, no fault codes
are present.
NOTE: Fault/Error codes cannot be cleared.
Exit Procedure
To exit Fault/Error Codes Display Mode,
turn the cycle selector knob or press and
hold POWER.