Owner's Manual
Table Of Contents
- Washer Safety
- Washer Safety
- Internet Connectivity Guide
- Choosing the Right Detergent
- Choosing the Right Detergent
- Adding Laundry Products
- Washer Maintenance and Care
- Cleaning the Washer Location
- Water Inlet Hoses
- Washer Care
- Clean Washer Cycle Reminder
- Removing the Dispenser
- Cleaning Load & Go™ Containers (on some models)
- Nonuse and Vacation Care
- Winter Storage Care
- Transporting Your Washer
- Reinstalling/Using Washer Again
- Cleaning the Drain Pump/Draining Residual Water (on some models)
- Additional Cleaning
- Installation Instructions
- Requirements
- Tools and Parts
- Location Requirements
- Drain System
- Electrical Requirements
- Installation
- Unpacking
- Connect Drain Hose
- Connect Inlet Hoses
- Level Washer
- Complete Installation Checklist
- Sécurité de la laveuse
- Sécurité de la laveuse
- Guide de connexion Internet
- Choix du détergent approprié
- Choix du Détergent Approprié
- Ajouter les produits de lessive
- Entretien et réparation de la laveuse
- Nettoyage de l'emplacement de la laveuse
- Tuyaux d’arrivée d’eau
- Entretien de la laveuse
- Rappel de lancement du programme Clean Washer (nettoyage de la laveuse)
- Retrait du distributeur
- Récipients Load & Go™ (sur certains modèles)
- Non utilisation et entretien avant les vacances
- Entretien pour entreposage hivernal
- Transport de la laveuse
- Réinstallation/réutilisation de la laveuse
- Nettoyage du filtre de la pompe de vidange / Vidange de l'eau résiduelle (sur certains modèles)
- Nettoyage supplémentaire
- Instructions d’installation
- Spécifications
- Outils et pièces
- Exigences d’emplacement (laveuse)
- Système de vidange
- Spécifications électriques
- L’installation
- Déballage
- Raccordement du tuyau de vidange
- Raccordement des tuyaux d’alimentation
- Établissement de l’aplomb de la laveuse
- Liste de vérification pour installation terminée
9
4. Remove large clumps of lint by hand from the filter and place
lint in a suitable waste container. Remove remaining residue
from the filter by rinsing with water.
5. Reinsert the drain pump filter by turning it clockwise. Make
sure to turn it in as far as it will go, with the filter handle
remaining as close as possible to the vertical position.
6. Replace and close the dispenser drawer. Make sure to insert
both rails simultaneously when replacing the drawer. You will
hear a clicking sound that indicates the rails have engaged. To
ensure proper placement of the drawer, pull out fully. The
drawer should be fully engaged and the rails locked in place.
Make sure the drain hose is secured in the hose clip and
tucked underneath the cutout.
Additional Cleaning
Gently pull back the rubber door seal and clean any stained areas,
soil buildup, or lint with the textured side of an affresh
®
Machine
Cleaning Wipe.
INSTALLATION INSTRUCTIONS
REQUIREMENTS
Tools and Parts
Gather required tools and parts before starting installation.
Tools Needed:
Adjustable or open end
wrenches 1/2″ (13 mm), 5/8″
(16 mm), and 9/16″ (14.3 mm)
Level
Wood block Ruler or measuring tape
Adjustable pliers that
open to 1 9/16″ (39.7 mm)
Flashlight
Bucket
Parts Supplied:
NOTE: All parts supplied for installations are in the washer.
Drain hose with clamp, U-form,
and cable tie
Parts Needed: (if not supplied with washer)
Inlet hoses with flat washers
NOTE: Various inlet hose
options are available; check
your Quick Start Guide for
ordering information.