Owner's Manual
Table Of Contents
- WASHER SAFETY
- Washer Safety
- Internet Connectivity Guide
- CHOOSING THE RIGHT DETERGENT
- Choosing the Right Detergent
- Adding Laundry Products
- WASHER MAINTENANCE AND CARE
- Cleaning the Washer Location
- Water Inlet Hoses
- Washer Care
- Clean Washer Cycle Reminder
- Removing the Dispenser
- Cleaning Load & Go™ Containers (on some models)
- Nonuse and Vacation Care
- Winter Storage Care
- Transporting Your Washer
- Reinstalling/Using Washer Again
- Cleaning the Drain Pump/Draining Residual Water (on some models)
- Additional Cleaning
- INSTALLATION INSTRUCTIONS
- REQUIREMENTS
- Tools and Parts
- Location Requirements
- Drain System
- Electrical Requirements
- INSTALLATION
- Unpacking
- Connect Drain Hose
- Connect Inlet Hoses
- Level WasherComplete Installation Checklist
- Complete Installation Checklist
- SECURITE DE LA LAVEUSE
- Sécurité de la laveuse
- Guide de connexion Internet
- CHOIX DU DETERGENT APPROPRIE
- Choix du détergent approprié
- Ajouter les produits de lessive
- ENTRETIEN ET REPARATION DE LA LAVEUSE
- Nettoyage de l'emplacement de la laveuse
- Tuyaux d’arrivée d’eau
- Entretien de la laveuse
- Rappel de lancement du programme Clean Washer (nettoyage de la laveuse)
- Retrait du distributeur
- Récipients Load & Go (sur certains modèles)
- Non utilisation et entretien avant les vacances
- Entretien pour entreposage hivernalTransport de la laveuse
- Transport de la laveuse
- Réinstallation/réutilisation de la laveuse
- Nettoyage du filtre de la pompe de vidange / Vidange de l'eau résiduelle (sur certains modèles)
- Nettoyage supplémentaire
- INSTRUCTIONS D'INSTALLATION
- SPECIFICATIONS
- Outils et pièces
- Exigences d’emplacement (laveuse)
- Système de vidange
- Spécifications électriques
- INSTALLATION
- Déballage
- Raccordement du tuyau de vidange
- Raccordement des tuyaux d’alimentation
- Établissement de l’aplomb de la laveuseListe de vérification pour installation terminée
- Liste de vérification pour installation terminée
- Untitled
6
3. If stained areas, soil buildup, or lint are found, wipe down
these areas of the seal using either of the following two
procedures:
a. affresh
®®
Machine Cleaning Wipes Procedure:
i. When the cycle is complete, gently pull back the
rubber door seal and clean the entire surface with the
textured side of an affresh
®
Machine Cleaning Wipe.
b. Dilute Liquid Chlorine Bleach Procedure:
i. Mix a dilute bleach solution, using 3/4 cup (177 mL) of
liquid chlorine bleach and 1 gallon (3.8 L) of warm tap
water.
ii. Wipe the seal area with the dilute solution, using a
damp cloth.
iii. Let stand 5 minutes.
iv. Wipe down area thoroughly with a dry cloth and let
washer interior air dry with door open.
IMPORTANT:
� Wear rubber gloves when cleaning with bleach.
� Refer to the bleach manufacturer’s instructions for proper
use.
Cleaning the Inside of the Washer
This washer has a special cycle that uses higher water volumes in
combination with affresh
®
Washer Cleaner or regular liquid
chlorine bleach to thoroughly clean the inside of the washer.
Steam washer models also utilize steam to enhance cleaning in
this special cycle.
IMPORTANT: Do not use thickened, easy-pour, or no-splash
bleach when running the Clean Washer with affresh
®
cycle as
excess suds may occur.
NOTE: Read these instructions completely before beginning the
cleaning process.
Begin Procedure
1. Clean Washer with affresh
®®
Cycle Procedure
(Recommended for best performance):
a. Open the washer door and remove any clothing or items.
b. Use an affresh
®
Machine Cleaning Wipe or a soft, damp
cloth or sponge to clean the inside door window.
c. Add an affresh
®
Washer Cleaner tablet to the washer
drum.
d. Do not add the affresh
®
Washer Cleaner tablet to the
dispenser drawer.
e. Do not add any detergent or other chemical to the washer
when following this procedure.
f. Close the washer door.
g. Select the Clean Washer with affresh
®
cycle.
h. On some models: Select the FanFresh
®
/TumbleFresh™/
Fresh Hold
®
/Fresh Spin™ option to help dry the washer
interior after the cycle is complete.
NOTE: The washer remembers your last option selection and
will use it for future wash cycles until you deselect that option.
i. Touch and hold Start/Pause to begin the cycle. See the
“Description of Clean Washer with affresh
®
Cycle
Operation” section.
2. Chlorine Bleach Procedure:
a. Open the washer door and remove any clothing or items.
b. Open the dispenser drawer and add liquid chlorine bleach
to the Max level in both the bleach compartment and the
fabric softener compartment. Either traditional or HE
chlorine bleach can be used.
IMPORTANT: Do not use thickened, easy-pour, or no-splash
bleach as excess suds may occur.
NOTE: Use of more liquid chlorine bleach than is
recommended above could cause washer damage over time.
c. Close the washer door and the dispenser drawer.
d. Do not add any detergent or other chemicals to the
washer when following this procedure.
e. Select the Clean Washer with affresh
®
cycle.
f. On some models: Select the FanFresh
®
/TumbleFresh™/
Fresh Hold
®
/Fresh Spin™ option to help dry the washer
interior after the cycle is complete.
NOTE: The washer remembers your last option selection and
will use it for future wash cycles until you deselect that option.
g. Touch and hold Start/Pause to begin the cycle. See the
“Description of Clean Washer with affresh
®
Cycle
Operation” section.
NOTE: For best results, do not interrupt cycle.
Description of Clean Washer with affresh
®®
Cycle
Operation
1. The Clean Washer with affresh
®
cycle will determine whether
clothing or other items are in the washer.
2. If no items are detected in the washer, it will proceed with the
cycle.
a. If any items are detected in the washer, “rL” (remove
load) will be displayed. The door will unlock. Open
washer and remove any garments from the washer drum.
b. Touch Power to clear the “rL” code.
c. Touch and hold Start/Pause to restart the cycle.
3. Steam models only: During the first 20 minutes of the cycle,
it will activate the steamer but the drum will not spin or fill with
water. You may see condensation on the door window during
this initial phase. If you are using an affresh
®
Washer Cleaner
tablet, it will not dissolve completely during the steam phase.
This is normal.
After the cycle is complete, leave the door open slightly to
allow for better ventilation and drying of the washer interior.
Cleaning the Dispensers
After a period of using your washer, you may find some residue
buildup in the washer’s dispensers.
For the Single-Load or Optimal dispenser: Remove the drawer
and wipe the surfaces with an affresh
®
Machine Cleaning Wipe or
a damp cloth, and towel dry either before or after you run the
Clean Washer with affresh
®
cycle. Use an all-purpose surface
cleaner, if needed.
For the Load & Go
™™ dispenser: Lift the handle on the dispenser
housing and pull to remove it from the washer cabinet; then rinse
the dispenser thoroughly with running water. Wipe the outside
dispenser surface with an affresh
®
Machine Cleaning Wipe or a
damp cloth, and towel dry. Use an all-purpose surface cleaner, if
needed.
Replace the dispenser in the washer cabinet and make sure that it
is correctly seated.
IMPORTANT: Dispensers are not dishwasher-safe.