Owners Manual
Table Of Contents
- WASHER SAFETY
- Washer Safety
- Internet Connectivity Guide
- CHOOSING THE RIGHT DETERGENT
- Choosing the Right Detergent
- Adding Laundry Products
- WASHER MAINTENANCE AND CARE
- Cleaning the Washer Location
- Water Inlet Hoses
- Washer Care
- Clean Washer Cycle Reminder
- Removing the Dispenser
- Cleaning Load & Go™ Containers (on some models)
- Nonuse and Vacation Care
- Winter Storage Care
- Transporting Your Washer
- Reinstalling/Using Washer Again
- Cleaning the Drain Pump/Draining Residual Water (on some models)
- Additional Cleaning
- INSTALLATION INSTRUCTIONS
- REQUIREMENTS
- Tools and Parts
- Location Requirements
- Drain System
- Electrical Requirements
- INSTALLATION
- Unpacking
- Connect Drain Hose
- Connect Inlet Hoses
- Level WasherComplete Installation Checklist
- Complete Installation Checklist
- SECURITE DE LA LAVEUSE
- Sécurité de la laveuse
- Guide de connexion Internet
- CHOIX DU DETERGENT APPROPRIE
- Choix du détergent approprié
- Ajouter les produits de lessive
- ENTRETIEN ET REPARATION DE LA LAVEUSE
- Nettoyage de l'emplacement de la laveuse
- Tuyaux d’arrivée d’eau
- Entretien de la laveuse
- Rappel de lancement du programme Clean Washer (nettoyage de la laveuse)
- Retrait du distributeur
- Récipients Load & Go (sur certains modèles)
- Non utilisation et entretien avant les vacances
- Entretien pour entreposage hivernalTransport de la laveuse
- Transport de la laveuse
- Réinstallation/réutilisation de la laveuse
- Nettoyage du filtre de la pompe de vidange / Vidange de l'eau résiduelle (sur certains modèles)
- Nettoyage supplémentaire
- INSTRUCTIONS D'INSTALLATION
- SPECIFICATIONS
- Outils et pièces
- Exigences d’emplacement (laveuse)
- Système de vidange
- Spécifications électriques
- INSTALLATION
- Déballage
- Raccordement du tuyau de vidange
- Raccordement des tuyaux d’alimentation
- Établissement de l’aplomb de la laveuseListe de vérification pour installation terminée
- Liste de vérification pour installation terminée
- Untitled
16
15. Adjust leveling feet
If washer is not level, use a 9/16" (14.3 mm) open-end or
adjustable wrench to turn jam nuts clockwise on feet until
they are about 1/2" (13 mm) from the washer cabinet. Then
turn the leveling foot clockwise to lower the washer or
counterclockwise to raise the washer. Do not exceed
2" (50 mm) from bottom of foot to bottom of cabinet. Recheck
levelness of washer and that all four feet are firmly in contact
with the floor. Repeat as needed.
HELPFUL TIP: You may want to prop up front of washer
about 4" (102 mm) with a wood block or similar object that
will support weight of washer.
16. Tighten leveling feet
When washer is level and all four feet are firmly in contact
with the floor, use a 9/16" (14.3 mm) open-end or adjustable
wrench to turn jam nuts counterclockwise on leveling feet
tightly against washer cabinet.
HELPFUL TIP: You may want to prop washer again with a
wooden block.
WARNING
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
17. Plug into a grounded 3 prong outlet
Complete Installation Checklist
� Check electrical requirements. Be sure you have correct
electrical supply and recommended grounding method.
� Check that all parts are now installed. If there is an extra part,
go back through steps to see what was skipped.
� Check that you have all of your tools.
� Check that shipping materials were completely removed from
washer.
� Check that the washer is level.
� Check that water faucets are on.
� Check for leaks around faucets and inlet hoses.
� Remove protective film from console and any tape remaining
on washer.
� Check that washer is plugged into a grounded 3-prong outlet.
� Dispose of/recycle all packaging materials.
� Read the “Washer Maintenance and Care” section.
� To test and clean your washer, press Power and choose the
Quick cycle and run it without clothes. Use only HE detergent.
Use 1/2 the manufacturer’s recommended amount for a
medium-size load.