® FRONT.LOADING AUTOMATICWASHER For questions about features, operation/performance, parts, accessories or service call: 1-800-253-1301 In Canada, call: 1-800-807-6777 or visit our website at www.whirlpool.com or www.whirlpool.ca ]_AVADO]_ AUTOMATICADE CARGA FRONTAL Si tiene preguntas respecto alas caracterfsticas, funcionamiento, rendimiento, pares, accesorios o servicio tecnico, Ilame al: 1-800-253-1301 En Canad& Ilame al: 1-800-807-6777 o visite nuestro sitio web en www.whirlpool.com o www.
TABLEOF CONTENTS INSTALLATION REQUIREMENTS ................................................ 4 Tools and Parts ............................................................................ 4 Options ......................................................................................... 4 Location Requirements ................................................................ 5 Drain System ................................................................................ 6 Electrical Requirements ..............
WASHERSAFETY Your safety and the safety of others are very important. We have provided many important safety messages in this manual and on your appliance. Always read and obey all safety messages. This is the safety alert symbol. This symbol alerts you to potential hazards that can kill or hurt you and others. All safety messages will follow the safety alert symbol and either the word "DANGER" or "WARNING.
INSTALLATION REQUIREMENTS Gather the required tools and parts before starting installation. The parts supplied are in the washer drum. Tools needed for connecting the water • Pliers (that open to 1%6" [39.5 mm]) • inlet hoses Flashlight (optional) Tools needed for installation • Open end wrenches 17 mm and 13 mm • Level • Wood block • Ruler or measuring tape Pedestal You have the option of purchasing pedestals of different heights separately for this washer. You may select a 10" (25.
Selecting theproperlocation foryourwasher improves performance andminimizes noiseandpossible washer "walk." Yourwasher canbeinstalled underacustomcounter, orina basement, laundry room,closet,orrecessed area.See"Drain System." Companion appliance location requirements should alsobe considered. Proper installation isyourresponsibility. Recommended installation spacing for custom undercounter installation The dimensions shown are for the recommended Custom undercounter installation spacing.
Recommended installation spacing for recessed or closet installation, with stacked washer and dryer The dimensions shown are for the recommended spacing. 46in?* (310cm2) The washer can be installed using the standpipe drain system (floor or wall), the laundry tub drain system, or the floor drain system. Select the drain hose installation method you need. See "Tools and Parts." Standpipe drain system - wall or floor (views A & B) The standpipe drain requires a minimum diameter standpipe of 2" (5 cm).
• Do not ground to a gas pipe. • Check with a qualified electrician if you are not sure the washer is properly grounded. • Do not have a fuse in the neutral or ground circuit. GROUNDING For a grounded, cord-connected washer: This washer must be grounded. In the event of a malfunction or breakdown, grounding will reduce the risk of electrical shock by providing a path of least resistance for electric current.
2. Oncetheboltisloose,moveittothecenteroftheholeand completely pulloutthebolt,including theplasticspacer covering thebolt. 3. Onceall4 boltsareremoved discard boltandspacers. Then pullthepowercordthrough theopening oftherearpanel and closetheholewiththeattached cap. 4. Closetheboltholeswiththe4 transport boltholeplugs. NOTE: Ifthewasher istobetransported atalaterdate,callyour localservice center.
Floor drain You may need additional parts. See Floor drain under "Tools and Parts." f. Check the electrical requirements. Be sure that you have the correct electrical supply and the recommended grounding method. See "Electrical Requirements." 1. Drape the power cord over the washer top. 2. 2. Secure the drain hose to the laundry tub leg or standpipe with the beaded strap provided. (See illustrations A and B.) Check that all parts are now installed.
FEATURESANDBENEFITS approved by Woolmark for the washing of machine _) The wool wash cycle products of this machine been washable Woolmark providedhasthat the i garments are washed according to the instructions %00[ MAF,K on the garment label and those issued by the manufacturer of this washing machine, M0614. Electronic Controls Flexible electronic controls are easy to use whether you are a beginner or an expert. Smart Dispensers The Smart Dispensers make your washer truly automatic.
WASHERUSE "3 NORMAL EstmatedTimeRemaning DELICATE Prewash Presoak Extra Rinse ®®@ OPIIONS DehyWash ! C0ntr01sLo_k/U,%ck IMdfe¢3Se_onds CLEANWASHER SOAK Hot ¸¸ill¸High _ Walm* D0o Locked I i_ Warm SuperH0t C01d ! NoSpi_ WaterTemp +Warm_i_se gelid _ Medium Low ExtraHigh i fx Heavy No real _ Lght S_i_ Soil Speed Level f_ L0_Jd Soft 0fi Cycle Signal Button _0u,_d o NOTE: The panel shown above may be different from that of your model.
The display shows the estimated time remaining. The preset settings provide the recommended fabric care for the selected cycle. See "Cycles." To fill dispenser compartments Select the desired Options. Not all options are available with all cycles. See "Options." 1. Pull out the dispenser drawer. 2. Add the desired laundry product to the proper compartment. 6. Select the desired modifiers such as Water Temp, Spin Speed and Soil Level. Not all modifiers are available with all cycles and options.
Liquid detergent: 1. To pause the washer at any time, press PAUSE/CANCEL. 2. To continue the cycle, press START (for approximately 1 second). Not all Options and Modifiers are available with all cycles. Available modifiers will glow amber. If an option or modifier is unavailable with a selected cycle, the light will not illuminate. Cycles, Options and Modifiers can be changed anytime before START is selected.
Add a garment This washer allows an 8-minute period in which other garments may be added to the load. You can add items to the washer if the Add a garment status light is glowing. To add items when Add a garment light is glowing 1. Select PAUSE/CANCEL items can be added. 2. To continue the cycle, close the door and select and hold START (for approximately 1 second). Cycles can be selected by turning the Cycle Control knob to the desired cycle.
Cycle Soil Level (cycle time) Water Temp Spin Speed Hand Washables Normal (0:30) Cold/Cold Low Quick Wash (2-3 items) Less soil (0:25) Warm/Cold Extra High N/A High Clean Washer Soak Normal (0:30) Warm/Cold No Spin Rinse/Spin Normal Cold/Cold Extra High N/A Extra High Delicate Use this cycle to clean hand washable and special-care garments. Similar to the way garments are hand washed in a sink, the wash action of this cycle combines periods of low speed tumbling and soaking.
Rinse/Spin Delay Wash Use this cycle to get a rinse and spin only. This cycle combines fast-speed tumbling and extra high speed spin. If desired, you can reduce the spin speed by selecting the speed you want from the SPIN SPEED modifier. Use this to begin the wash cycle later. • Select DELAY WASH until the desired time (in hours) shows in the Estimated Time Remaining display. A Rinse/Spin cycle is useful for • Select START. The countdown the display window. • Loads that need rinsing only.
Preset cycle settings of Water Temperature, Spin Speed, and Soil Level can be changed. You can change a modifier after starting a cycle anytime before the selected modifier begins. Not all modifiers are available with all cycles and options. Available options will glow amber. Current selections will glow green. If a modifier is unavailable with a selected cycle, the light will not illuminate. Wash/Rinse Temp Select a water temperature based on the type of load you are washing.
LAUNDRYTIPS Preparing clothes for washing Follow these recommendations to help you prolong the life of your garments. • Use only High Efficiency detergents, The package for this type of detergent will be marked "HE" or "High Efficiency." This wash system, along with less water, will create too much sudsing with a regular non-HE detergent.
WASHERCARE The Washer Maintenance procedure should be performed on a monthly basis. 3= Cleaning the Door Seal 1. Open the washer door and remove any clothing or items from the washer. 2. Inspect the gray colored seal between the door opening and the basket for stained areas. Pull back the seal to inspect all areas under the seal and to check for foreign objects. Open the dispenser drawer and immediately add ¾ cup (160 mL) of liquid chlorine bleach to the bleach compartment.
Replace inlet hoses after 5 years of use to reduce the risk of hose failure. Periodically inspect and replace inlet hoses if bulges, kinks, cuts, wear or leaks are found. To use washer again: 1. Flush water pipes. Reconnect water inlet hoses to faucets. Turn on both water faucets. When replacing your inlet hoses, record the date of replacement. _,ac,,..,, _ ,,b{{> _a#,<> ad ]}I i_v _;i (,;_de Install and store your washer where it will not freeze.
TROUBLESHOOTING First try the solutions suggested here to possibly avoid the cost of a service call... Washer Washer displaying code message and tone sounds won't start "F20" (Water Inlet Problem--no water or insufficient water supply) Select PAUSE/CANCEL twice to cancel the cycle. Unplug washer or disconnect power.
Washer stops • Dispensers clogged or leaking Checkthe following: Is the power cord plugged into a grounded 3 prong outlet? Are the laundry products in the correct dispenser compartment? Add the correct amounts of detergent, fabric softener or liquid chlorine bleach to the correct compartments. Add powdered or liquid color-safe bleach to the Main Wash compartment. Be sure to match powdered color-safe bleach with powdered detergent or match liquid color-safe bleach with liquid detergent.
Stainsonload • Cycle too long Did you add detergent to the dispenser? For best results, add detergent to the detergent compartment. Do not add detergent to the washer drum. Did you use enough HE detergent? Use enough detergent to remove soil and hold it in suspension. Use only HE detergent. Follow the manufacturer's instructions to determine the amount of detergent to use. Is there above average iron (rust) in water? You may need to install an iron filter.
ASSISTANCEOR SERVICE Before calling for assistance or service, please check "Troubleshooting." It may save you the cost of a service call. If you still need help, follow the instructions below. For further If you need further assistance, you can write to Whirlpool Corporation with any questions or concerns at: When calling, please know the purchase date and the complete model and serial number of your appliance. This information will help us to better respond to your request.
WHIRLPOOLCORPORATIONMAJORAPPLIANCEWARRANTY ONE YEAR LIMITED WARRANTY For one year from the date of purchase, when this major appliance is operated and maintained according to instructions attached to or furnished with the product, Whirlpool Corporation or Whirlpool Canada LP (hereafter "Whirlpool") will pay for Factory Specified Parts and repair labor to correct defects in materials or workmanship. Service must be provided by a Whirlpool designated service company.
M0614 WOO[ MARK 461970235721 © 2006 Whirlpool Corporation. All rights reserved. Todos los derechos reservados. Tous droits r_serv_s. ® Registered Trademark/TM Trademark of Whirlpool, U.S.A., Whirlpool Canada LP licensee in Canada The Woolmark symbol is a registered trademark of The Woolmark Company. ® Marca registrada/TM Marca de comercio de Whirlpool, EE.UU., usada bajo licencia de Whirlpool Canada LP en Canada El simbolo Woolmark es una mama registrada de The Woolmark Company.
