Installation guide

Installation clearances:
The location must be large enough to allow the dryer door to open fully.
Most installations require a minimum 51/2'' (140 ram) clearance behind the dryer for the exhaust vent with elbow. See "Venting
Requirements."
29" Wide Models 27" Wide Models
Dryer Dimensions Dryer Dimensions
433/8 II
(1102mm}
I
*26"
(660 ram}
43 ,i
(1092 mr
*29%
,4 ...... (749 mm)
.... 27"
(737ram) (737rnm) .... _- (687 ram} - _"_687
ram)
A B
A B
(737ram}
D
r ¸¸_ .... _ i-ii_
43318'' ----_-_-_- (5_8mm) 43318"i
(ll02mm)l I !_I/_ (1102mm}ll
(705ram)'_L........ ::-:: '-]' _ (705mm)_
(737rnrn)
C
A. Large opening side-swing door
B. Large opening side-swing door
C, Wide opening side-swing door
D. Wide opening hamper door
installation Spacing
_14" max,' -
48in_*
_ I._ II;._mm 310cm}2_
[_ 24in.2.-
-.. ._ (155cm)2
o,oii
(457mm_,
(76ram}
(7_rnmI
1"-_ _- 2g"-_ I_- 1" -_1"*_ 273_")_5_/2"_{-
(25ram) (737mm) (25ram)(25mm}(705mm}(140ram)
A B
A. Recessed area
B. Side view - closet or confined area
C. Closet door with vents
C
*Required spacing
A, Large opening side-swing door
B. Wide opening hamper door
installation Spacing
-- _ %in'__
(4_78 _ (310cm)
1"_ I_ 27"-,-IF-I" ÷11"F 29'/,"Hsv_"*F-
(25ram}(686rnm)(25mm)(25mm}(748mm}(148mm}
A B
*Required spacing
E}
C
A. Recessed area
B. Side view - closet or confined area
C. Closet door with vents
_f 3 I1.
-_6ram)
==_3 ]I*
(76mm)
T
installation spacing for recessed area or closet
The dimensions shown are for the minimum spacing allowed.
[]
[]
[]
[]
[]
Additional spacing should be considered for ease of
installation and servicing.
Additional clearances might be required for wall, door, and
floor moldings.
Additional spacing of 1" (25 mm) on all sides of the dryer is
recommended to reduce noise transfer.
For closet installation, with a door, minimum ventilation
openings in the top and bottom of the door are required.
Louvered doors with equivalent ventilation openings are
acceptable.
Companion appliance spacing should also be considered.
Mobile home = Additional installation requirements
This dryer is suitable for mobile home installations. The
installation must conform to the Manufactured Home
Construction and Safety Standard, Title 24 CFR, Part 3280
(formerly the Federal Standard for Mobile Home Construction and
Safety, Title 24, HUD Part 280) or the Canadian Manufactured
Home Standard CAN/CSA-Z240 MH.
[] Metal exhaust system hardware, available for purchase.
For further information, please reference the "Assistance or
Service" section of the "Dryer User Instructions."
[] Special provisions must be made in mobile homes to
introduce outside air into the dryer. The opening (such as a
nearby window) should be at least twice as large as the dryer
exhaust opening.
6