Installation guide

CONNECT VENT
(a
1 » Gonnect vent to exhaust outlet
Using a 4" (102 mm) clamp, connect vent to exhaust outlet
in dryer. If connecting to existing vent, make sure vent is
clean. Dryer vent must fit over dryer exhaust outlet and inside
exhaust hood. Check that vent is secured to exhaust hood
with a 4" (102 mm) clamp.
( 2. Move dryer to final location
LEVEL DRYER
(4 . Level Dryer
Place
level here
Move dryer to final location. Avoid crushing or kinking vent.
After dryer is in place, remove cardboard from under dryer.
Check levelness of dryer from side to side. Repeat from
front to back.
NOTE: The dryer must be level for the moisture sensing system
to operate correctly.
SS
Not Level LEVEL Not Level
ee
AT
:
Models
with
riser
Models
without riser
( 2. Adjust leveling legs
if dryer is not level, prop up using a wood block, use wrench
to adjust legs by backing out the foot as needed, then checking
again for levelness. Once legs are level, make sure ail four legs
are snug against the floor.
17