Installation Guide

17
5. Reverse outer window assembly
Using a Phillips screwdriver, remove the 4 screws from the
outer window retainer and lift off the trim ring off the window
(A). Rotate trim ring 180° and secure with the 4 screws
removed earlier (B).
Handle
Fig. A
Fig. B
Handle
6. Rotate and reassemble outer window
assembly to trim ring
With the edge with 2 notches at the top, align the notches
on the outer window assembly with the tabs on the trim
ring and lower into place as shown in figure A. Rotate the
outer window assembly counterclockwise to lock tabs into
place (B). Using a Phillips screwdriver, secure with 2 screws
removed earlier.
IMPORTANT: Do not overtighten.
Fig. A
Fig. B
Bottom
of door
Notches