Installation guide

iNSTALLATiON REQUIREMENTS
TOOLS AND PARTS
Gather the required tools and parts before starting installation.
" , tall_
Flat-blade screwdriver
#2 Phillips screwdriver
Parts supplied (all models):
Leveling legs (4)
Parts supplied {steam models):
1/4" and 5/16" nut driver Level
recommended)
"Y" connector
2' (0.6 m) inlet hose
Tape measure Pliers
Rubber washer
Utility knife Tin snips (new vent installations)
Caulking gun and compound Adjustable wrench that opens to
(new vent installations) 1" (25 mm) or hex-head socket wrench
Tools needed for gas installations:
8" or 10" pipe wrench
Pipe-joint compound
resistant to LP gas
4
8" or 10" adjustable wrench
(for gas connections)
Parts package is located in dryer drum. Check that all parts
are included.
NOTE: Do not use leveling legs supplied with dryer if installing
with a pedestal or a stack kit.
Parts needed: (Not supplied with dryer)
[] Vent clamps
[] Vent elbows and vent work
Parts needed {steam models):
5' (1.52 m) inlet hose
Additional parts may be required, depending in your installation.
Check local codes. Check existing electrical supply and venting.
Read "Electrical Requirements" and "Venting Requirements"
before purchasing parts.
Optional Equipment: (Not supplied with dryer)
Refer to your Use and Care Guide for information about
accessories available for your dryer.